p0016
-
B
P0016 runs great, no rough idle or hesitation to throttle
I recently installed a stage 2 vvt cam, disabled MDS lifters and have beehive springs, push rods the whole works including base tune so I can drive it until I get it fine tuned. The problem is I can disconnect the battery (-) post and reconnect and drive for miles no issues what so ever, but if...- BlackSpider
- Thread
- p0016 stage 2
- Replies: 0
- Forum: Engine & Performance
-
J
2016 Ram 3.6 liter P0016 & P0017 codes - help?
Need help to resolve these codes in 3.6 liter. Is there a Cam/Crank relearn process that applies with cam swap? Other causes? Could my timing chain bank 1 be stretched. Background - changed cylinder 3 rockers to try to resolve P0303 misfire code (now fixed). But I incorrectly installed cam...- Joeyboat
- Thread
- 3.6 rocker arms 3.6l cam cam crank relearn p0016 p0017 ram 3.6 l timing misalignment vvt phaser
- Replies: 1
- Forum: V6 Engine & Performance
-
D
P0014 p0016 and p000B trouble codes
Hello, I have a 2010 ram with the 5.7 with 197k miles that ran and drove great up until about a week ago. I took it on around a 500 mile round trip and it did great. Upon starting it up the next morning the check engine light came on and the truck was in limp mode (awful throttle response and...- dkelly3103
- Thread
- p000b p0014 p0016 vvt solenoid
- Replies: 5
- Forum: General Discussions
-
2012 Ram 1500 5.7L Hemi Camshaft/Crankshaft Sensor Repair Advice
Good morning everyone, I hope you all are doing well. I wanted to see if I could get some advice for tackling this error I keep getting with the timing on the 5.7Hemi. Here are the things I have replaced so far. Year: 2012 Model: Outdoorsman Truck Mileage: 156,000 Crankshaft Sensor: Replaced...- jlyalls
- Thread
- 2012 ram hemi cam phaser camshaft hemi 5.7 p0016 repair tensioner timing chain.
- Replies: 6
- Forum: Engine & Performance
-
M
2010 5.7 Dodge Ram
P0016. 180 k Runs very good but CEL came on with P0016 - P0340. Changed spark plugs, Cam Sensor, Crank Sensor, and VCT solenoid. Went through 5 drive cycles and CEL came on again, this time only P0016. It seems to be thrown at deceleration and advance timing is around 4 degrees. It runs very...- mikhen7
- Thread
- p0016 timing
- Replies: 0
- Forum: Engine & Performance
