Custom Front Wind Splitter

[tourdemon]

Splitter was cut from a sheet of Alumalite which is a strong, aluminum composite panel with a high-density corrugated polyallomer core that will not swell, corrode, rot, wick water, or delaminate. I then wrapped it in 3M Di-noc carbon fiber. Adds a whole new dimension to the truck.

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

 

[Budakane]

#winning!! That's badass!!

 

[GzNutz]

Pretty cool mod. Looks sweet.

 

[RR7_905RAM]

Nice custom work dude!!

 

[sbarron]

That looks spectacular!

 

[usaf2006]

Now youre ready to partake in some european circuits lol.

 

[Beauregard7765]

Thats pretty cool

 

[charonblk07]

That's killer, I could seriously use one for my truck, the hood lifts way too much at 273km/h.

 

[xb1230]

So from my reading, a wind splitter should extend from the front twice the measure from the ground to underneath the surface... Yours is too short...

Mine would have to extend almost 3 feet out... LOL

Imagine those folks running a 6 inch lift !

Killer looks though... Great job !

 

[Stangshcky12]

Being corrugated, what does the edge look like?

 

[tourdemon]

Being corrugated, what does the edge look like?

I applied the Front Wind Splitter Trim from APR performance to the edge, fits perfectly.

 

[Booms]

Must . Have . This .