Quicksilver337
Senior Member
- Joined
- May 27, 2012
- Posts
- 690
- Reaction score
- 138
- Location
- South FL
- Ram Year
- 2016 Ram R/T
- Engine
- Hemi 5.7
When you install the plates that have notches that help line then up but you are the one who drills the 2 bolt holes in the back, not to mention that there is a little more wiggle room for the bars on the new brackets. Its only about 3/32 out which is with in acceptable range for most alignment shops but my does setup for race cars so he's a perfectionist. Besides i was gonna get cutterups bars no matter what so I don't mind. He'll if it was a chevy that would be stock lol so many of them drive down the road crab walking.
My rear alignment was spot on... weird
didn't read if you installed a relocation bracket along with an adjustable panhard bar?
I placed washers between the relocation brackets and the control arms to prevent movement side to side. Also when you tighten the bolts on the control arms the truck has to be sitting at normal ride height(tires on level surface)