Nubster
Senior Member
Got my Kenwood double DIN headunit last week. Ordered the recommended PAC C2R-CHYNA. Arrived today. Pulled the factory headunit again to do the install and the PAC doesn't fit. So now I don't know what to do other than cut the factory harness and start splicing. Doesn't really matter to me, I'll do it. Hell with reinstalling the factory radio if I sell/trade the truck in the future. I just want to get the new headunit in. I'm just not sure what wires go to what. I know the speaker wires, but the other wires have me confused.
Factory:
I know the speaker wires. The yellow w/red stripe power. Black w/red stripe ground. What are the two white wires next to the yellow?
Kenwood harness:
Black to black. Where does the yellow and red go? Both to the yellow w/red stripe?
Kenwood harness:
No idea where any of the labeled wires go
This is a non-Alpine system. No amp. No steering wheel control.
Can someone please help?
Factory:
I know the speaker wires. The yellow w/red stripe power. Black w/red stripe ground. What are the two white wires next to the yellow?
Kenwood harness:
Black to black. Where does the yellow and red go? Both to the yellow w/red stripe?
Kenwood harness:
No idea where any of the labeled wires go
This is a non-Alpine system. No amp. No steering wheel control.
Can someone please help?