KissMyHemi
Junior Member
I bought the 2/4 belltech drop kit for my ’13 quad cab, and in the instructions for the rear install, it says, “ Crossmember Notch, This section is for 2013 models with 140.5” wheelbase only.” (ok check)
“Also this section ONLY applies to … Single piece Driveshafts only.” (ok check again…)
I looked under my truck for this crossmember that needs to be notched out, but I don’t even see a piece of the crossmember that is even wide enough to attach the supplied steel plate after notching…
So, my question is this for those here that has installed one on their truck same year and model as mine… did you have to install the steel plate? Am I looking at the wrong place here, because the crossmember is way narrower than the supplied steel plate. I don’t even see where to bolt the thing in…
“Also this section ONLY applies to … Single piece Driveshafts only.” (ok check again…)
I looked under my truck for this crossmember that needs to be notched out, but I don’t even see a piece of the crossmember that is even wide enough to attach the supplied steel plate after notching…
So, my question is this for those here that has installed one on their truck same year and model as mine… did you have to install the steel plate? Am I looking at the wrong place here, because the crossmember is way narrower than the supplied steel plate. I don’t even see where to bolt the thing in…