I have a question about torsion bars. It states "Torsion Bar sales codes will be found on Vehicle Identication Number [VIN] Sales Code Listing."
Where do I find that Sales Code listing on my truck?
Hello,
Thank you for providing that information. I will research it further, but thought it may be an input shaft seal after research. Do you happen to know where the best place to purchase this with highest quality is?
Hello all,
I have a photo showing where there is a leaking seal at the front of the driveshaft. I don't know exactly what the terminology for this seal is, and if anyone could offer some input it would be most appreciative.
05 Ram 1500 4WD 4.7L SLT
I live in Massachusetts.
I'm going to make one more attempt to fit the cover on before spending hundreds of dollars on the backing pieces and fasteners. The bolt holes line up on the cover I received, just seems that there is something in the way not allowing me to install.
Thank you for that link. I was viewing that yesterday and could not find a lot of differences or a way to remove the chrome front as shown in the second picture I posted. I was told this was an all in one design and would have to get the "make-up" for a sport bumper include the backing to do the...
Hello,
Thank you for the response. I will post a photo (I hope it comes out) that shows the point where I'm at.
Any pointers on what the next step is or what needs to be removed?
Hi all,
I have a 2005 1500 SLT with the front and rear chrome bumpers. I received a black bumper cover which looks to have the same bolt patterns but still appears to be a few inches off from attaching over the chrome. I removed the air deflectors, and the step pad as well as the silver (color...
Hello,
I have attached a diagnostic list which may help you with the issue. Essentially this could be as simply as a Camshaft position sensor defect or crankshaft sensor defect, or it could be an issue with the tone wheel/pulse ring going bad.
I hope this helps.
427invader, do you have any other symptoms such as your turn signals not working properly, or parking lights/ running lights not working?
Did all of the leds go out all at once, or did one go, and the rest went out?
Hey m4mckeen,
That looks really good. I like the present look, but once I get the truck to the next step it may be an option.
The only thing I dislike about the Spyder headlights are the adjusting screws having to be accessed by removing the headlight completely. Makes the adjustments more...
Hello,
Coil G will be for cylinder 7, and located on the driver side furthest coil back.
I know that if you search for Wells Vehicle Electronics for the coil, they sometimes have a way to test the coil for possible failure.
POSSIBLE CAUSES
- Good trip equal to zero
- (K342) ASD relay...
Hey all,
I haven't been fully active on this forum lately, but two weekends ago I installed Spyder Halo LED headlights on my 2005 Ram 1500 SLT.
Spyder part number for these headlights is: PRO-YD-DR02-HL-BK
The outcome was very nice, and the wiring was pretty simple.
There were two...
P0869
Possible Causes
- (F856) 5-VOLT SUPPLY CIRCUIT OPEN
- LINE PRESSURE SENSOR CONNECTION
- (T140) PRESSURE CONTROL SOLENOID CONTROL CIRCUIT OPEN
- (F856) 5-VOLT SUPPLY CIRCUIT SHORT TO GROUND
- (T140) PRESSURE CONTROL SOLENOID CONTROL CIRCUIT SHORT TO GROUND
-...
I have ordered mirrors from two separate vendors, and have not noticed discoloring. If you don't mind me asking where did you order the original towing mirrors from?
I have used 1A Auto, and a Dodge Dealership through eBay for my 05 1500.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.