Recent content by spacedace
-
S
Help!! Fuel leak at fuel rail input. 97 2500 5.9 gas.
Is this correct- spacedace
- Post #2
- Forum: General Discussions
-
S
Help!! Fuel leak at fuel rail input. 97 2500 5.9 gas.
Hello everyone. So months back I thought I was having an issue with my fuel pump. Turned out to be a wiring connector…so I pulled the quick connect clip at the fuel rail to test for fuel. Anyway…I don’t drive this much and a month ago I saw it leaking, pulled it out and the o ring was...- spacedace
- Thread
- Replies: 3
- Forum: General Discussions
-
S
Hazard/signal lights stay on
SOLVED!!!! So I took the cluster out and did a continuity test on each bulb and the power/ground on the film. All was good. Then I bench test off a battery 12v in the illumination wire and grounded. All lights worked. Same for turn signal and high beam. Tested the pin connectors on truck and all...- spacedace
- Post #5
- Forum: Audio & Electronics
-
S
Hazard/signal lights stay on
Thanks...I am trying to find which is the ground for it. I checked the switch and the dimmer portion is sending voltage to the fuse, then from the fuse from an orange wire to the back of the dash. Probing it, and adjusting the dimmer, you get the voltage fluctuation depending on where the dial...- spacedace
- Post #4
- Forum: Audio & Electronics
-
S
Hazard/signal lights stay on
just added info...as far as the exterior of the truck, everything works. pull the switch halfway, running lights come on, however on the dash the green arrows are on, pull the switch to full and the headlights come on, but the dash denotes high beams....pull the column lever to switch to high...- spacedace
- Post #2
- Forum: Audio & Electronics
-
S
Hazard/signal lights stay on
Here’s an interesting one. Before we get too deep yes I installed two new flashing units. The hazards operate correctly when the column button is depressed. The turn signals work fine as well. However, when I pull the lights switch to half and full position, both green arrows illuminate on...- spacedace
- Thread
- Replies: 4
- Forum: Audio & Electronics
-
S
Hey everyone
Sorta new here. Former 04 Rumble Bee owner, current gen 2 owner...Dodge guy for 20 years....on my fourth Challenger. Just dropping in to say hello. Currently working on my 97 2500 hoping to find it a good home soon.- spacedace
- Thread
- Replies: 5
- Forum: Introduction
-
S
1997 2500 Rwal abs/brake/no speedometer
delete...resolved- spacedace
- Post #2
- Forum: General Discussion
-
S
1997 2500 Rwal abs/brake/no speedometer
Gentleman and Gurus. I have seen and read many threads about this, however I am in a bit of a pickle here. I didn't want to just be a parts replacer, but easy enough for what I have done already. Two weeks ago I got into the truck which I don't drive often and saw the abs light on and brake...- spacedace
- Thread
- Replies: 1
- Forum: General Discussion
