Search results

  1. B

    1500 3.21 gears

    I have a 2013 with 3.21 gears and a 5.7, I pull a 4200 lbs truck with a trailer weighing 2600 lbs, with weight distribution hitches and electric trailer brakes. I have pulled it from Michigan to North Carolina with no issues.
  2. B

    Bilstein or leveling kit for height

    so if I am reading right the bil's or the Ranchos up front, we do not need to replace the control arms on a 2013? Thank you Rob
  3. B

    2013 Ram Tune Question

    Anyone running the 87 octane tune on the Diablo I2 on their rams? I have an 2013 Ram with the A8 trans and drive it daily. I always run 87 in it except when towing. Just looking for a little more power and maybe some better gas mileage.
  4. B

    7 pin connector falling out

    ok have the factory setup, I used the lock on the cap and took it for a drive, around sharp corners or a good series of bumps it disconnects then reconnects itself. I am going to check for loose grounds and wires.
  5. B

    7 pin connector falling out

    I knew about the lock and had some issues with it while locked in. I bend the pins in some and try this weekend. Thank you
  6. B

    7 pin connector falling out

    when I hook up my trailer, my trailer connector is not making a tight connection and sometimes when I pull the trailer the connector will move and loose contact. is there any good way to tighten up the connection points, I tried a very small screw driver. thank you Rob
  7. B

    Hellcat in a ram

    the 9.25 rear end is a strong rear end, the weak point is the limited slip unit..put in a good one like a detroit locker and you are all set.
  8. B

    How many miles out of a tank of gas? 5.7 Hemi

    I have seen 22 miles to the gallon before. that was driving from buffalo to detroit. Normally highway I see about 19 miles driving.. Depending on how much my foot is in it I see about 500+ miles to a tank. 32 gallon tank, 3.21 gears 8 speed 4 x 4 quad cab.
  9. B

    Using a sway bar on a 1500 Express to stabalize loads?

    User, what I posted is designed to go into your 2" receiver hitch, its not the hitch itself but a bar that goes into it and allows for you to adjust for a bad load set up. You still need the receiver tube. I have a factory one on my ram and it works nice. I hear they are not that expensive...
  10. B

    Using a sway bar on a 1500 Express to stabalize loads?

    user, My set up is a 18 ft jb enterprise trailer, that I have a box mounted on the tongue. the trailer has about a 4 ft beaver tail. Its the same setup as rob rohe uses on his ram except he does not have a trailer box mounted yet. Rohe has a regular cab and loads his so that the back tires...
  11. B

    Using a sway bar on a 1500 Express to stabalize loads?

    user I just towed mine to the RT Nats, I have the rear sway bar on my ram, but what really helped me was my weight distribution hitch. I have a cc and a 18 ft flat bed trailer, with the last 4 ft beaver tailed.
  12. B

    What Do You Tow With Your 4th Gen?

    last weekend towed a 4200 lbs Dakota RT on the trailer. Trailer weighs about 2200 lbs from Detroit to Mooresville NC. Got 14 miles to the gallon round trip. Thats with the 3.21 gears going up and down some 5% grade hills. Handled it no problems.
  13. B

    Flip down rear seats done!

    just finished this modification, very easy with the 3/4" nuts as spacers...why didnt the ram come this way from the factory
  14. B

    *** BedRug Blowout Group Buy Sale ***

    is this still going on? I am interested in the 5'7" with ram boxes. what mods would I need to do to the rug to get it to work with my bed divider.
  15. B

    what do you tow with 3:55s

    no pictures but i have a 18 ft full floor car hauler that is about 2500 lbs and then tow either my dart which is about 3200 lbs or my dakota which is about 4200-4300 lbs. No problems ever when towing
  16. B

    No CD player

    The CD player is an option from the factory on these trucks. Mine is in the bottom glovebox in the center of the 2 front bucket seats.
  17. B

    amp turn on and constant power

    thank you, got it installed
  18. B

    amp turn on and constant power

    where is everyone taping their amp turn on wires into and the constant for their locs? I bought the fuse taps that go into the fuse panel, I got the smallest ones I could find and they do not fit. Apparently the fuses are even smaller than the fuse taps I could find. So I think I am going to...
  19. B

    Speaker/sub setup - NEED HELP

    I think thats the same box I just ordered. I am thinking of putting a JL10W3 in it. My box should be here this weekend. I already have a old punch amp that I am going to drive it with and I did the AudioControl2IC or something like that to convert the signal. I had RF subs, Kicker, MTX and...
  20. B

    Need some feedback

    do you load up the torque converter or launch at idle? did hemifever turn off torque management? Chrysler usually pulls timing out if you load up the converter to keep the weak trans safe.
  21. B

    Cat Delete?

    If you do take your cat off, try taking the rear most 02 sensor and putting it in the frame rail, so that it reads fresh air. depending on which cat is bad and how many you have, this trick should work. the last 02 sensor looks for a difference from the front one and as long as it sees a...
  22. B

    Getting the power to the ground...

    for diff covers might want to look at something like LPW racing or a cover similar to theirs. I have one on my dakota and it has set screws that you tighten against the bearing caps for extra strength. I have their ultimate series.
  23. B

    HBS 2" Level Install ... Ran into a problem..

    I would try your local parts store, maybe in the help section they will have new boots.
  24. B

    rancho quicklift

    thank you guys, wife wanted to know what to get me for xmas (she has to start early or i just buy what I want.) Looks like I will be seriously looking for a set of these.
  25. B

    rancho quicklift

    anyone try them for leveling the front. I was thinking of using the bil's but these come loaded and are priced not bad.. found them at RA just wondering the quality. thank you Rob

Latest posts

Staff online

Members online

Total: 625 (members: 27, guests: 598)
Robots: 1,697

Forum statistics

Threads
195,697
Posts
2,873,409
Members
156,572
Latest member
Joey93

Share this page

Top