Search results

  1. N

    Aftermarket LED Tail Light for NON LED Factory models working with LED models

    I have a 2014 Ram 1500 Laramie. it has the factory LED tails. I bought a set of Spyder after market tails for the truck. they clearly state it is not for the LED tail models. I remedied that by buying two 3157 sockets and wired them up. I have the tails working now. but just barely. Truck is...
  2. N

    Using Factory air ride buttons to control aftermarket rear air bags

    As the title states, I haven't found anyone doing this yet, so I figured I would ask. I have found a button cluster with all of the controls for $140, my 2014 Laramie 1500 has everything except air ride. I am looking to get an airlift load lifter 5000 kit for towing my boat. I need to figure out...
  3. N

    Swapping 2014 auto zf transmission for another (same zf)

    I had a previous thread up but its gone kind of sideways since I started it. was troubleshooting an issue with the trans. Long story short, failed attempts to fix, still don't know whats wrong, but I'm now looking to replace. original thread here if anyone wants a backdrop or more info on the...
  4. N

    Just bought a 2014 5.7 4x4 Laramie A8... What is wrong with this Trans?!

    So I went to look at this truck. Had been sitting on the lot since May. On a cold start, I did notice a small stutter when shifting but only when barely on the throttle. Truck would rev a tad higher than what one would expect, then the RPM would fall proportionate to the next gear, but instead...
  5. N

    Why is my 5.9 magnum ticking?!

    212,000 miles Brand new QP casting stock heads from Odessa (Fully assembled) Truck never ticked before or after top end rebuild. Driving 70 mph down the interstate one day and hear what sounds like an agresively loud watch ticking. Motor was at 1500 rpm or so? When I tightened the rockers...
  6. N

    Climate control only HOT

    I tried a search, found some people with various problems, but nothing similar. I was thinking blend door, but it could be vacuum or dash control? So all my controls work good. Except temp. It scorches my ass. Lol I know where about the blend door and actuator are located, but I think it...
  7. N

    What are these lines for?!

    99 ram 1500. 4x4. i noticed some damaged metal lines that look line brake lines the other day when i was under the truck... have no clue what they are to. on the front axel, there is a box casted with brake lines running to it. there are rubber/plastic lines that run away from this, down...
  8. N

    Engine Boggs randomly at idle, tapers off to die if not gassed, and sucks wind

    What is this? I'm thinking its a sensor failure. I just don't know which one. When it does it, it's only at idle. I first hear the vacuum start to suck wind, it almost whistles. Right after my rpms will slowly start to go down until the truck is bogging so bad it dies. You can...
  9. N

    what to do to a 5.9 magnum to bring it to life?!

    i just got the truck. all factory motor wise. has a body lift and 35"s. drive good, but motor is not very responsive, and only seems to have sufficient power when i smack it over the head. lol but then again, i may be spoiled because i just parted ways from daily driving a chevy 350 small block...
  10. N

    Just bought my first dodge truck, what is throwing the cyl 7 misfire code?

    so as title states, P0307 code is only code truck is throwing. (1999 ram 1500 4x4 with the 5.9) i figured i would buy a spark plug to see if $2 would solve my check engine light issue, and it did! for about 50 miles worth of driving. truck would rarely bogg and if no gas was applied, die, if...

Latest posts

Members online

Total: 1,053 (members: 49, guests: 1,004)
Robots: 1,465

Forum statistics

Threads
196,130
Posts
2,878,282
Members
157,206
Latest member
misfitarmy

Share this page

Top