question to those of you who have added aux. reverse lights and are using a back up camera. my truck is a 2013 express.
i recently added two led back up lights. i wired them using a relay and to a 3 way switch on the dash. i wired them so the lights are triggered by the reverse wire on the hitch connector when the switch is in 1 position, the other two positions on the switch are off completely, and on all the time.
the question i have for you guys is, have any of you experienced interference with the back up camera when aux lights are on? the camera and relay trigger for the aux lights tie into the same reverse wire on the 7 pin connector. i made a jumper to trigger the aux lights from the reverse wire at tail light itself, and still had the static lines on the screen. the aux lights are grounded to a bumper bolt (chassis) if that helps with any info on my setup. any ideas on how to block out the interference these lights are causing with the back up cam? also, the back up cam is an aftermarket unit tied into my pioneer head unit and has worked problem free since i installed it back in 2013. any help is greatly appreciated. thanks!