BigRed4x4
Senior Member
- Joined
- Apr 24, 2015
- Posts
- 590
- Reaction score
- 235
- Location
- Mid Michigan
- Ram Year
- 2014
- Engine
- Hemi 5.7
So.... I just had the Bil's installed and set at 2.1 on 35" ridge grapplers. A couple things I've noticed since...
1.) The front measures 39 7/8" vs the back 39 3/8".
a.) Shouldn't the back still be a bit higher than the front at 2.1?
1.) Haven't measured all 4 corners but I'll do that today.
2.) They ride harder, or more firm than stock which is fine but there is also a rattle/noise/bumping sensation when I hit small bumps in the road at any given speed. Something feels loose but I wasn't able to find anything when I crawled underneath to check. I'm no mechanic and have no experience with this type of install, fyi. I had a shot install.
There was a post on a ram facebook group about the same situation on a members truck and he mentioned the CV axle shaft going bad or possibly the new angle since the level causing this type of issue.
Any insight?
1.) The front measures 39 7/8" vs the back 39 3/8".
a.) Shouldn't the back still be a bit higher than the front at 2.1?
1.) Haven't measured all 4 corners but I'll do that today.
2.) They ride harder, or more firm than stock which is fine but there is also a rattle/noise/bumping sensation when I hit small bumps in the road at any given speed. Something feels loose but I wasn't able to find anything when I crawled underneath to check. I'm no mechanic and have no experience with this type of install, fyi. I had a shot install.
There was a post on a ram facebook group about the same situation on a members truck and he mentioned the CV axle shaft going bad or possibly the new angle since the level causing this type of issue.
Any insight?
Last edited: