I have the common rust problem around the rear wheel wells and want to cover it up with some flares. I need flares anyone since I put the 305/55/20s on stock wheels with 1.5" spacers. Width isn't the big issue, the height is.
I really like the Bushwacker pocket flares but their website says they are 4" high. I kinda need something a little higher than that though, but what I was wondering is how the height is measured. Around the curves of the wheel wells, it appears that the flares are a little bit wider and I was wondering if anyone who has them could confirm.
The extend a fender flares are listed at 5" high and I have seen some other brands at 4.25-4.5". Another one that intrigues me is the flares made by a company called Tyger Auto. They are listed at over 5.5" high and are supposedly made from the same material as the Bushwackers but they are super cheap, so I don't know...
I would appreciate it if those who have Bushwackers on their trucks could snag a few measurements around the whole flare for me. Thank you!
I really like the Bushwacker pocket flares but their website says they are 4" high. I kinda need something a little higher than that though, but what I was wondering is how the height is measured. Around the curves of the wheel wells, it appears that the flares are a little bit wider and I was wondering if anyone who has them could confirm.
The extend a fender flares are listed at 5" high and I have seen some other brands at 4.25-4.5". Another one that intrigues me is the flares made by a company called Tyger Auto. They are listed at over 5.5" high and are supposedly made from the same material as the Bushwackers but they are super cheap, so I don't know...
I would appreciate it if those who have Bushwackers on their trucks could snag a few measurements around the whole flare for me. Thank you!