headers install

[tantore]

hi guys can any one tell me if a video is available on haw to install headers on a2012 ram 1500 5.7 l. engine any help will be great thanks Ray

 

[whetrick1]

Check YouTube


Sent from my iPhone using Tapatalk

 

[tantore]

i did no luck

 

[Hemi450hp]

Which headers are you installing? Are you 2wd or 4wd?

This is a pretty straight forward install though. If you can take the stock manifolds off, then you shouldnt have any trouble putting the new ones on.

 

[DILLIGAF]

JBA's fit like ****, Avoid them if you can.

 

[tantore]

hi mat i want to install the shorties that i want to buy from you in the next few weeks will be in touch thanks for the feed back to all

 

[nickpohlaandp]

JBA's fit like ****, Avoid them if you can.

Headers fit fine, JBA's Y-pipe fits like ****.

hi mat i want to install the shorties that i want to buy from you in the next few weeks will be in touch thanks for the feed back to all

I wouldn't waste your money on shorties. Spend it elsewhere or get long tubes.

 

[Gary's Hemi]

Headers fit fine, JBA's Y-pipe fits like ****.



I wouldn't waste your money on shorties. Spend it elsewhere or get long tubes.

Didnt you install a 6 speed y pipe on an 8 speed truck though?

 

[nickpohlaandp]

Didnt you install a 6 speed y pipe on an 8 speed truck though?

No. The Y just fits like ****. It was a 6 speed Y on a 6 speed truck.

 

[jag1886]

I wouldn't waste your money on shorties. Spend it elsewhere or get long tubes.

I wish people would stop just automatically saying this. The people that say this have obviously never looked a set of stock manifolds, Ram must have spent $5 designing them, anything is an upgrade over stock manifolds.

I installed a set of shorties on my truck and it made a noticeable difference in the performance.

 

[DILLIGAF]

Headers fit fine, JBA's Y-pipe fits like ****.

Actually, Having to dent the pipe for the steering shaft to clear is **** ! And Im not the only one that had that problem,

Never read anywhere ARH having that issue.

So I stand by my first comment JBA's are ****. And I regret not waiting a few more paychecks and savings for ARH.

 

[nickpohlaandp]

Actually, Having to dent the pipe for the steering shaft to clear is **** ! And Im not the only one that had that problem...

Ok, I'll give you that.

 

[Csanders1992]

Best advice I have is to pull the front plastic wheel well liners out. That's how I installed long tubes on old Chevy and it made it a lot easier


Sent from my iPhone using Tapatalk

 

[nickpohlaandp]

This is a no-brainer, must do. It will save you a lot of busted hands and time. It takes 5 minutes to do, do it.

On my LS powered truck everything was easy enough to access from the top. On the Hemithe best advice I ever got was to remove the plastic wheel wells.