Help system install

[Bigblueram1500]

I know this question has been asked several times but I was hoping for some help. I have a 2015 Ram with the 5 inch uconnect touchscreen and the 6 speaker system. I'm wanting to install my line out converter so I can hook up my subs anybody have any step by step instructions on how to do so for the line out converter. Like where do I get power for it and what location do I tap into

 

[Graygoose]

Which amp you using, some can handle speaker level input, so no LOC needed.

 

[Bigblueram1500]

It's a kicker amp 600 wat with a single 10 inch sub

 

[Bigblueram1500]

 

[Graygoose]

You don't need an LOC. Those can handle speaker level in.


The new CXA4001, close to what you have.
https://www.kicker.com/CXA4001-400-Watt-Mono-Class-D-Subwoofer-Amp

speaker to RCA
https://www.kicker.com/2-channel-speaker-rca-converter

 

[Bigblueram1500]

How would I go about wiring that up?

 

[kkreit01]

If you use the high-level inputs, tap the rear speaker wires (you can find those in the B-pillars). Run your power all the way to battery via the empty clutch plate in firewall. Run a short, clean ground. Hopefully your amp will automatically sense the signal, so you do not need a remote turn-on?

 

[Bigblueram1500]

The line out converter I got in the mail today from kicker it's a two channel with two sets of speaker wires on it and a ground

 

[Graygoose]

you get this?

 

[Bigblueram1500]

you get this?
View attachment 160639

That's the one I bought I'm going to try and wire it in tomorrow

 

[Graygoose]

Ok sounds good,
any question, phone techs are 8-5pm CT, at 1-800-256-0808 to assist.