What did you do with your 4th Gen this week?

[usaf2006]

View attachment 150488 Used mine for one of many upcoming trips for our move from Md. to SC

What's your lift setup? Your truck has a great stance. Unless those aren't 35s lol

 

[usaf2006]

Got my JBA shorties installed but I am thinking I may have a leak, not sure though could just be hearing the normal ticking better now. I really hope there isn't a leak as I don't know if I can make myself go back in there again. This install made putting long tubes on my '02 Z28 look like a walk in the park. I haven't taken it for a drive yet as I am not done with the rear shocks but that should make it obvious if there is a leak.

View attachment 150505

On a side note while I was crawling around under the truck I found signs that the transmission might have been pulled in the past. There were a couple brackets hanging without bolts for the transmission lines and some other cables but everything else looked good.

Did you use mopar gaskets? I've heard other brands tend to leak

 

[LoneStarSilver]

One of the biggest differences I found in the sound of my exhaust was when I installed the 5" tips. The sound became a lot deeper and mellower(sp). I have a Magnaflow 22".
Jay

I am definitely going to look into the 5” tips. Yesterday I put over 300 miles on the truck. Took the wife with me since, she has super sensitive hearing, to see if she noticed any drone or annoyingly loud noise. All went well!! I’m really loving this muffler!

 

[Pull Ya]

Those 5" tip ain't cheap but I was really surprised by the difference in tone. I think Matt keeps them in stock and they are pretty easy to put on. I had mine tacked on just to deter someone one from trying to take them.
Jay

 

[local]

Did you use mopar gaskets? I've heard other brands tend to leak

Technically, I used Fel-Pro which is the manufacturer of the Mopar gasket. They were identical to the ones I took off. I honestly think I may have just not gotten them torqued properly. Some of those bolts were almost impossible to get anything on them to tighten.

 

[Donutsahoy]

Installed Westin running boards on the beast last night. Christmas present from my parents. The Fiancée is much happier and now I can start thinking about a leveling kit


Sent from my iPhone using Tapatalk

 

[Pull Ya]

Installed Westin running boards on the beast last night. Christmas present from my parents. The Fiancée is much happier and now I can start thinking about a leveling kit
Sent from my iPhone using Tapatalk

You have learned the secret!!! LOL
Jay

 

[mboymopar]

Installed Westin running boards on the beast last night. Christmas present from my parents. The Fiancée is much happier and now I can start thinking about a leveling kit


Sent from my iPhone using Tapatalk

Looks great!

 

[HEMI_Finn]

Finally wrapped the side air vents chrome trim with black carbon fiber.

 

[tones2SS]

FINALLY cleaned my windshield. lol
It wasn't terrible, but it's been bothering me for a while now.

 

[Outdoors76]

Took steps off will repaint with bed liner.. Paint chipping and rust! Ughh..

Added the factory mopar mid flaps onto my flares they fit nicely

 

[LoneStarSilver]

Installed Westin running boards on the beast last night. Christmas present from my parents. The Fiancée is much happier and now I can start thinking about a leveling kit


Sent from my iPhone using Tapatalk

Very nice and keeping the Fiancé happy is a positive as well!! You are learning grasshopper!!

 

[Outdoors76]

 

[Addicted2fishing]

Installed Westin running boards on the beast last night. Christmas present from my parents. The Fiancée is much happier and now I can start thinking about a leveling kit


Sent from my iPhone using Tapatalk

I could paint my truck hot pink and my wife wouldn’t notice [emoji12]


Sent from my iPhone using Tapatalk

 

[dirtyd1833]

Rolled my 2014 1500 past the 110,000 mile point. All trouble free miles.

Makes me feel a little better about my '15 with 85k. Only issue other than recalls were the dreaded manifold bolts....

Sent from my SM-N950U1 using Tapatalk

 

[dirtyd1833]

Over the last month I installed a Ranchhand front bumper, got my manifold bolts replaced, put on an 18" magnaflow and had my son put on the light bar today... set up with the homelink. Next up, wheel spacers.

Sent from my SM-N950U1 using Tapatalk

 

[Jaywoo]

Makes me feel a little better about my '15 with 85k. Only issue other than recalls were the dreaded manifold bolts....

Sent from my SM-N950U1 using Tapatalk

Just the recalls for me and the regular oil changes every 9000 miles or so. It's so reliable I've named it Trigger, my trusty steed.

 

[4eyedconekiller]

Took steps off will repaint with bed liner.. Paint chipping and rust! Ughh..

Added the factory mopar mid flaps onto my flares they fit nicelyView attachment 150539 View attachment 150540

That’s a pretty shot there... Gonnahve to take mine off and do the same thing soon. Do you have wheel spacers on your truck?

 

[4eyedconekiller]

Over the last month I installed a Ranchhand front bumper, got my manifold bolts replaced, put on an 18" magnaflow and had my son put on the light bar today... set up with the homelink. Next up, wheel spacers.

Sent from my SM-N950U1 using Tapatalk

Would like to know how you setup the light bar with the homelink...

 

[Gordinho80]

Is $150 for a used mufflex 18” magnaflow a good deal? Some surface rusting on it.