Recent content by mamboloco
-
M
ABS Module replacement
Hi, I had Brake and ABS lights on, inoperative speedometer issue with P500 code. replacing the rear sender didn't fix the issue so I got a used ABS module off ebay, same part number and installed it. This fixed the error, and solid brake light/ABS light combo. Now, the ABS just blinking at...- mamboloco
- Thread
- Replies: 1
- Forum: Audio & Electronics
-
M
P500 Speed sensor error
I had a chance to pull the ABS CAB connector and check things out. 1) I can measure resistance between 1 and 8 (rear sensor) about 2k Ohms 2) B+ voltage is OK at both pins 7 and 14 with respect to 6 and 13 (GRND) 3) pin 4 has voltage with ignition on So, the module has power and sensor input... -
M
The one truck I wish I had never sold
I bough a 2001 STD cab cummins with manual speed @ 30K miles in 2007.. I regret selling it to this day.- mamboloco
- Post #17
- Forum: General Discussions
-
M
P500 Speed sensor error
well I have the P0500 error, abs + brake light on, speedometer inop, and need to let go of the gas for shift problem... I replaced the sensor on the rear axle, checked the abs fuse and checked the cable near the sensor. still have the issue. I suspect it's corrosion at the ABS module... -
M
power loss after injector swap
As I suspected the cable had jumped from under a black plastic guide to over top of it. it's nice and powerful again :)- mamboloco
- Post #5
- Forum: Engine & Performance
-
M
power loss after injector swap
ok, I think I may be onto something. When I replaced the injectors I was operating the throttle wide open, looking at the plenum and recall it snapping back once and maybe it's cable is off track or something? the pedal seems to have a lot of play upwards, so I am thinking this might be...- mamboloco
- Post #4
- Forum: Engine & Performance
-
M
power loss after injector swap
I don't think you need to bleed them. it starts, idle is smooth just lacks power. no lean or rich error codes. only thing I can think of is the some of the injectors got cross wired and are gasing out of sequence. my cables are not labeled but they *look* to be in the right order on the...- mamboloco
- Post #3
- Forum: Engine & Performance
-
M
power loss after injector swap
Hi, I recently installed refurbished bosh 4 port injectors and the truck starts, idles smooth but has very little power. to get it going I almost have to floor it. I've checked the connectors to make sure they are plugged in the right order. Anything else that might cause this? There are...- mamboloco
- Thread
- Replies: 5
- Forum: Engine & Performance
