Recent content by Mr M

  1. Mr M

    Mystery vibration at 50mph+

    I will give that a try after I check the hubs, if they find issues using that method, do they balance differently? Thanks!
  2. Mr M

    Mystery vibration at 50mph+

    My 2012 2500 Regular cab 8' bed has a course vibration mostly felt in the steering wheel and through the truck at exactly 50mph and over, smooths out below 50, Just had rear u joints replaced and shaft balanced, new front driveshaft, new passenger side axle joint, and a freshly rebuilt xfer case...
  3. Mr M

    TPMS Sensor Issues

    I am on my 2nd TMPS sensor for my front-right wheel (all were replaced with new wheels 2-months ago) and I STILL cannot get a reading on my display in the truck. It worked initially with all the others, then stopped, I replaced it, still cannot get it to work. I DID ping it with my buddy's...
  4. Mr M

    Need Locking Diff Advice

    Hi All, I am looking to add a locking diif (posi) rear or front to my rig. As I plow snow I am not at all getting good traction (with brand new aggressive tires and years of experience) this truck is just terrible in the snow. I was looking at a Yukon Gears unit for around $400. Cant decide if...
  5. Mr M

    New Transfer Case Issues

    I understand completely, unfortunately it's actually a large rebuilding company that I should have researched better because it appears that there's a lot of Google complaints on their engine rebuilding problems and them not honoring warranties, I went with them because they offered a 3-year no...
  6. Mr M

    New Transfer Case Issues

    The play is up, down, right, left, hence circular...unloaded and yes, assembled, its newly rebuilt with 128 miles on it. 2 mechanics have looked at it, they feel its excessive, but they arent rebuilders. So, my original question of does anyone else have any play of this magnitude? I do have...
  7. Mr M

    New Transfer Case Issues

    Hello All, Just replaced the transfer case in my 2012 2500 (front case was cracked from bad driveshaft) Driveshaft was replaced, and I just installed a new ("professionally" rebuilt) transfer case (NP2710) and I believe it is defective....there is a lot of circular play in the front output...
See more

Latest posts

Staff online

Members online

... and 3 more.
Total: 1,340 (members: 53, guests: 1,287)
Robots: 1,566

Forum statistics

Threads
195,816
Posts
2,874,817
Members
156,774
Latest member
mkrainwater

Share this page

Top