Recent content by Rod Plunger
-
Hi Beam Circuit tie-in
I know this is an old thread... I am trying to tap into my high beam as well to get a trigger for an led light bar. I found my bcm, but it is so tucked up in there and behind what looks like an amplifier, that I don't know how I'd ever get there. So, can I just tap into the actual power wire for...- Rod Plunger
- Post #41
- Forum: 4th Gen DIY
-
-
-
Running Board Choices
Hi all, Any insight or recommendations on running boards/side steps? I don't plan on off-roading, so I don't need sliders. Mainly it is for ingress and egress so I don't destroy the seat. I don't personally want them too low, nor do I want them too wide. I have found the three linked here that I...- Rod Plunger
- Thread
- Replies: 4
- Forum: Exterior
-
-
AlfaOBD and Parking Sensors
The faults I am getting are B1296 PTS Sensor 9 Performance or incorrect operation Last Test failed erreor present Failure warning lamp 'ON': Requested AND B1298 Same fault but sensor # 11 Wires don't look corroded to me. I live in Seattle and we don't use salt. We see rain, but nothing...- Rod Plunger
- Post #8
- Forum: Audio & Electronics
-
AlfaOBD and Parking Sensors
Was this for your "front" sensors, or was it for the rear. And I assume you are talking about outside of the vehicle? In the wheel well behind the liner there, and not inside the cab below the dash... Thanks- Rod Plunger
- Post #7
- Forum: Audio & Electronics
-
AlfaOBD and Parking Sensors
Ah, ok. Thank you! Hopefully I can track it down. Any usual suspects in the system that make it not work?- Rod Plunger
- Post #4
- Forum: Audio & Electronics
-
AlfaOBD and Parking Sensors
Hi All, New to the truck, and new to the forum. I have searched to the best of my ability, but can't find an answer so I am sorry if this is a repeat. I have a 2013 1500 Bighorn that I am getting the "Service Parksense Sensors" alert whenever I go into reverse. I do not have front sensors. I...- Rod Plunger
- Thread
- Replies: 9
- Forum: Audio & Electronics
-
Replacement speaker question
Do you have a link for the Kickers you used? Thanks...- Rod Plunger
- Post #18
- Forum: Audio & Electronics
-
Help! Another bricked Uconnect
Another question is if anyone knows of software that skips the Sierra wireless card during the upgrade? That way I can bypass the failed Sierra wireless card and get back to something.- Rod Plunger
- Post #2
- Forum: Audio & Electronics
-
Help! Another bricked Uconnect
Hi all. New to the forum, and new to my Ram. Since no good deed goes unpunished I am sorry to report that I have put my 8.4 VP4 from my 2013 1500 Big Horn into a dreaded update loop whilst attempting to upgrade the software. I get to step 11 with the Sierra Wireless Card update and it crashes...- Rod Plunger
- Thread
- Replies: 3
- Forum: Audio & Electronics
-
Uconnect software update...boot loop
Have you gotten this resolved? I went to update the software and am now stuck in the "sierra wireless card" loop. I have been all over the web and none of the tricks seem to work (pull usb at 1%, hold buttons for 20 seconds, temperature buttons up and down, ) and nothing has helped. I am...- Rod Plunger
- Post #6
- Forum: Audio & Electronics
-
Members online
- duckman631
- crackerjack1957
- 06 Dodge
- Smokeybear01
- Daniel12
- Spywiz
- Dinky
- Dickencider90
- AZ MARK
- mb33458
- Rav3ncroft
- Dmoe0911
- Vilianaywd
- Wild one
- raggydoo
- 4xdad
- Dredger
- Slinge
- buckeyexx
- Arthurw
- Woodsrunner28
- David Langford
- RAMET
- TomT
- commander
- CanRebel
- 18harvest
- Docwagon1776
- Riccochet
- datsmer53
- CrazyHarleyGuy
- zstroken
- dieres2010
- CROD
- san1sjd
- Recon5869
- michaelcarlson2
- rzr6-4
- GTyankee
- sigfla
- aszumilo
- sluchak
- Curmudgeon
- Racer9
- Ken226
- Fuelie
- bardownski
- xlcjw72
- andygl
- Mecco22