Rod Plunger
Junior Member
Hi All,
New to the truck, and new to the forum. I have searched to the best of my ability, but can't find an answer so I am sorry if this is a repeat.
I have a 2013 1500 Bighorn that I am getting the "Service Parksense Sensors" alert whenever I go into reverse. I do not have front sensors.
I have replaced all 4 sensors on the bumper, have AlfaOBD on my android phone, and have successfully paired to a bluetooth OBD II device. I have also uploaded my log for my truck to make sure I can get back to basics.
Can someone tell me the steps I need to take in AlfaOBD (assuming I can!) for "flashing" the sensors? Or "reseting" the sensors? Or is there something else I need to do, besides visit a stealership? I seem to be a bit stuck and would like to get them working again.
Thanks for any advice.
New to the truck, and new to the forum. I have searched to the best of my ability, but can't find an answer so I am sorry if this is a repeat.
I have a 2013 1500 Bighorn that I am getting the "Service Parksense Sensors" alert whenever I go into reverse. I do not have front sensors.
I have replaced all 4 sensors on the bumper, have AlfaOBD on my android phone, and have successfully paired to a bluetooth OBD II device. I have also uploaded my log for my truck to make sure I can get back to basics.
Can someone tell me the steps I need to take in AlfaOBD (assuming I can!) for "flashing" the sensors? Or "reseting" the sensors? Or is there something else I need to do, besides visit a stealership? I seem to be a bit stuck and would like to get them working again.
Thanks for any advice.