I swapped out my Carven for a Borla when I did my longtubes. That little Carven sounded like **** with the LT's. Couldn't be happier with the Borla muffler. About half as loud, smoother and still aggressive when I want it to be
Lol, this thread is 4 yrs old. With that being said, the answer is yes. I was able to successfully put a 13+ bumper and grill on my 2011. The only thing that didnt line up was the lower grill clips. Nothing a few zip ties couldn't take care of
Zone 6/5 with bils set @ 2.8 on 35"s sometimes the shark fin rubs, sometimes it doesnt. But it fits. I think my original measurement was like 36 1/4" up front. Now I'm 44 front/ like 45" rear. 7' garage header
Borla pro xs. Swapped out my Carven progressive for this after installing headers. I liked the Carven a lot before the long tubes. After it was waay too loud. Got annoying after a few months. So far no drone with the borla. Was getting bad drone with the Carven at interstate speeds. Lots of...
There is a pretty good write up with video in the DIY section. I'm sure drilling the hole shaves off about half the time. Unclipping the window, taping it up, and removing the inner panel to unscrew the hadles from the inside takes about an hr a door if you've never done it.
Did mine by myself on garage floor a year ago. Get some swivel extensions for a 1/4 inch ratchet. Also a swivel head ratcheting box end wrench. Those bolts are a ***** to get to, to tighten down. I used the hardware that came with the arh headers and reflex gaskets. Have a welder handy if you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.