Search results
-
Exhaust Tube Size
I've been sitting on a replacement muffler for a while to replace my flowmaster 3" in 2.5" out dual muffler. Currently the tube from the cat is 2.5" to the flowmaster. Should I replace the 2.5" pipe with 3" from the cat to the muffler or leave it 2.5"? Would there be any benefit to increasing...- kpd12
- Thread
- Replies: 5
- Forum: Engine & Performance
-
Inverting OD Switch - DIY
Overdrive Switch Invert Mod Edit: I should hope it goes without saying, but I accept no responsibility for anyone screwing up there vehicle while attempting this modification. It worked for me and although it's only been a couple days, I have seen no adverse affects from completing this...- kpd12
- Thread
- Replies: 10
- Forum: 2nd Gen DIY
-
Need to vent
I will begin by saying that although I would prefer to get a SCT Tuner from Sean, I do not currently have that kinda spare cash and seems like every time I get close to having what I need to make the purchase, something more pressing comes up. So recently when I found a Superchips 3815 eBay for...- kpd12
- Thread
- Replies: 15
- Forum: Engine & Performance
-
Driveshaft rubbing fuel tank skid plate
So for a while now I've noticed a rubbing noise when I go up an incline at an angle. I had checked for signs of rubbing on the exhaust and for anything loose underneath, yet hadn't located the source until yesterday. While pulling up some buried supports for a playscape I had to drive over a... -
Coil Spacers and Control Arms
I am looking to level my 01 Ram with Off Road package and have been searching the web to try and find these answers, but am honestly only getting a headache with everything and not getting the actual answers. I know that several have leveled their ORE without changing control arms and some have... -
Infamous Plenum Gasket
So I am about to start ordering parts to replace my plenum gasket and planning on replacing my timing set at the same time, I am sitting at 153xxx miles on the original. Can you guys tell me if I am missing anything? I am going to take Merc225hp’s advice and keep the original steel plenum plate...- kpd12
- Thread
- Replies: 5
- Forum: Engine & Performance
Members online
- Bmags
- TC
- Manyard
- Rickcumm
- Choicebro
- Dinky
- Smokeybear01
- rall01
- bucnut
- Tysclassics
- Slinge
- Flip-er
- fireflymedic
- Rdjo
- Docwagon1776
- 06 Dodge
- sy440
- mb33458
- Mrsmith4
- Daniel12
- huntergreen
- Travis8352
- wildcat12
- Jbmac
- RebelDad
- DoughRat19
- Dodge 1500 4X4
- Pears
- Maniac
- JoshsRam
- Jamesg0418
- pros1k
- BenWade
- central_texan
- andres124501
- Thendrix
- seanhawn19
- Brandon-w
- austin2144
- Ducatidom
- Obito
- 08MegaLong
- RamTek
- smoothee
- Gstrat
- Kid's HEMI! !!
- jayquelin
- Bobwilla123
- Curmudgeon
- Ken226