Search results
-
P77 Recall Pinion nut
I'll be surprised if they cover anything. My truck is up and running and feels much better than even when I first bought it (though I bought it used). Aftermarket pinion nut also has safety precautions to prevent backing out. -
New Differential Install - Failure
Reviving this from the past, hope you don’t mind. Friend and myself are currently rebuilding my 9.25 on my 2007 4x4 where the pinion nut came off. Got replacement gears (same ratio, 3.92) and Timken bearings and seal. We don’t have the pinion depth tool to check the proper pinion depth and we...- G8rDuc
- Post #13
- Forum: Engine & Performance
-
P77 Recall Pinion nut
Interesting they would skip a couple of years inbetween for the recall. :( glad yours is good! Sent from my iPad using Tapatalk -
2007 Water Pump
Let me just state that I hope you used a Mopar pump. And check that connection on the #1 coil. Sent from my iPad using Tapatalk- G8rDuc
- Post #15
- Forum: General Discussions
-
P77 Recall Pinion nut
What year is your truck? Thought the recall was only on 09-10? Just had this happen to my 07 and I’ve spent about $600 in parts while me and my friend are rebuilding it this week. Sent from my iPad using Tapatalk -
Stupid Radio canbus, anyone do it?
Is this an 08 thing? My 07 didn’t have that issue when I installed an Alipine Ilx-007 Sent from my iPad using Tapatalk- G8rDuc
- Post #4
- Forum: Audio & Electronics
-
P127E
Just spoke with a person that is a Dodge service tech, he said when they get them into the shop, they actually add a relay onto the TIPM for this purpose. Now I need to get a Fuel pressure gauge and see if it's getting enough pressure or maybe the pump is the actual culprit (of course, it will...- G8rDuc
- Post #5
- Forum: Engine & Performance
-
P127E
Doesn't the 07-08 TIPM have the ASD and Fuel Pump functions built in to the circuit board of the TIPM and not relay'd?- G8rDuc
- Post #3
- Forum: Engine & Performance
-
P127E
Need some troubleshooting help. Was driving my 2007 1500 Laramie 4x4 5.7 on Friday. Pulled into my neighborhood, stopped to talk to a neighbor and while the truck was idling, it died. Tried to restart and it was trying to turn over but acted like no fuel. Neighbor towed me home. I was thinking...- G8rDuc
- Thread
- Replies: 4
- Forum: Engine & Performance
-
No heat on driver side
Just a FYI, I have the same issue and it's the A/C control switch. When mine was bad, I would have to slide the temp slide back and forth and it would finally work. Replaced it and voila.....blend doors are an uncommon problem with the dual zone. -
Lockpick in a 3rd gen?
Had the airbag light issue and they couldn't resolve it. Went to the lockpick RER combo then eventually got tired of the factory limitations and went aftermarket radio. Couldn't be happier. Sent from my iPad using Tapatalk- G8rDuc
- Post #2
- Forum: Audio & Electronics
-
Combination of HVAC problems
Sounds like what I'm experiencing but also with the temperatures :( Sent from my iPad using Tapatalk -
Combination of HVAC problems
It's actually perfect inbetween! Just have to get it to respond to the temperature sliders first, lol. -
Combination of HVAC problems
I'll give that a shot next time and see. I'm really leaning toward the A/C Dash switch since I have to keep flipping the appropriate knob or slide around until I get results...just wish there was a way to test it! -
Combination of HVAC problems
I have a 2007 Ram 1500 with Dual Zone air. First thing I noticed is that I barely get air to the feet area. Just a little bit and it's always been an issue. But recently, when I change the temperature of either zones, sometimes it works, sometimes it doesn’t. I have to slide the temp controls... -
Backup cam install
Wish I would have seen this earlier. Someone did this awhile ago on one of the forums and it came out great. I've done it since and I've also replaced the camera a couple of times (stupid cheap eBay cameras). I am about to replace my camera with a non-flush unit. It's the type that has an...- G8rDuc
- Post #12
- Forum: 3rd Gen DIY
-
-
MyGIG Value?
I placed the GPS antenna where my factory GPS was located, under the front dash (just unsnaps), front and center. Wire feeds right up to it. I'm not positive on the aftermarket amps and subs. I would assume so since you can use adapters to make a factory radio work with aftermarket subs. I would...- G8rDuc
- Post #17
- Forum: Audio & Electronics
-
MyGIG Value?
Yes sir. That's correct. PayPal is gatorjimbo @ g8rduc dot com If you need references, eBay name is Anuszewski. Think I've crested over 500 positive 100% transactions:) Sent from my iPhone using Tapatalk- G8rDuc
- Post #15
- Forum: Audio & Electronics
-
MyGIG Value?
I can pull it all out this weekend. I'll include all of the harnesses and adapters. That would include: The Radio (of course). It's the REN MyGig (from a 2008 Chrysler 300). Has the latest update, clock fix, 2015 maps. Hell, I'll leave my music on there for you, feel free to delete them, ROFL...- G8rDuc
- Post #13
- Forum: Audio & Electronics
-
MyGIG Value?
Yes to both questions. I have a backup camera hooked up to it with the camera mounted in the factory tailgate "spoiler" piece. Works great. And yes to paypal as long as you pay any fees (or just paypal gift it).- G8rDuc
- Post #11
- Forum: Audio & Electronics
-
MyGIG Value?
I'm not in a hurry, so go ahead and sell your setup and I'll wait.- G8rDuc
- Post #9
- Forum: Audio & Electronics
-
MyGIG Value?
Let me know if you're interested. Otherwise I'll probably put it on ebay Sent from my iPhone using Tapatalk- G8rDuc
- Post #7
- Forum: Audio & Electronics
-
MyGIG Value?
Where are you located? I'm probably going to ask around $550 for all of it, plug and play.- G8rDuc
- Post #5
- Forum: Audio & Electronics
