Search results

  1. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    Update...found a short in a line to the pcm. Tested continuity on negative terminal and got a hit on a hot pin on the pcm connector. Also showing a short at one of the o2 sensors on bank 2. Update you guys when I get more into it
  2. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    Oh shit. That's right, I have an obd2 Bluetooth that does. But yeah, I believe the Diablo does but not as detailed. I will check it asap, but got a lead today with a continuity check. Found a bad ground somewhere in the engine harness. I believe it's at my O2 sensor. Sent from my moto g(6)...
  3. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    No shrader valve, where do I put adapter? Sent from my moto g(6) using Tapatalk
  4. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    Yes that test is what confirmed the bad lifter destroyed cam back in july. That repair cost me almost $6000 with me doing all of the labor. But I also replaced with upgraded all new ignition and fuel injectors. Did't change lbs on injectors, just got a good brand.
  5. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    Yes, COP are good. Push rods where in great shape. it now has hellcat oil pump and lifters. oil pressure was normal. All test where done 700 miles after cam swap. Leak down, compression, vacuum etc. all was great. She ran so good for almost 2 months.
  6. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    I already swapped back to old pcm and had same effect,map is new, air intake charge temp is new, there isn't a throttle positioning sensor (thanks ram) guess it is built into the electronic throttle body, will test ignition coils, o2, engine coolant temp, and injectors next. But the coils and...
  7. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    Someone give me a simple list of Most reasons truck would run too rich: please when you have time
  8. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    Have the scan tool, it has only thrown 2 codes. p0175 and p0506. One is low idle air control the other is too rich fuel. I replaced the purge, map, pcv already. Only got cyl.- 1,2,3,4 plugs out and 1-2 look really bad, 3-4 look ok but covered in fuel. Want to take the valve covers off to check...
  9. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    It is a nice forum, first and only one I have ever been part of. I going to call it quits for today I now have another headache. LOL Thanks again guys, will keep you all posted. Sent from my moto g(6) using Tapatalk
  10. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    I will continue testing O2 sensors and other ideas. I have a buddy that may let me swap his throttle body over to mine to see if that's the problem thank you guys for the help I'll be going offline for a little while while doing this I'll check back in later Sent from my moto g(6) using Tapatalk
  11. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    yes all injectors seem to be working correctly no leaks all the coils seem to be fine the truck run on 7 cylinders for 2 weeks and ran at least ran you know like now it won't stay idling it'll die Sent from my moto g(6) using Tapatalk
  12. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    as far as looking at the two codes on all data and other websites the only one component listed on both possible causes was the map sensor that's why it was the first thing replaced and all the other things listed - the PCM has been checked and replaced Sent from my moto g(6) using Tapatalk
  13. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    I meant to add that earlier sorry yes the throttle body was clean very thoroughly when I took the intake off during the cam swap cuz I pulled the entire engine out of the truck to clean the valves seeing if that stuff needed to be replaced sent the heads off to get looked at, but yeah the...
  14. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    This is what I'm leaning towards so far but I have no way to test unless someone knows a way to test, the throttle body is an electric throttle body there is no air temperature control or air fuel mixture control on these if the throttle body motor thinks it's in one spot but it's not wouldn't...
  15. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    I have both a Haynes manual and all data account I did do the carb cleaner around the vacuum lines and thought I heard a difference but I couldn't get it to do it again but it also changes so much that it's hard to tell I got a total of three codes two were these two P0175 P0506. the last one I...
  16. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    So far all seem good but it's hard to tell with the strange way they label these fuses Sent from my moto g(6) using Tapatalk
  17. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    as far as I can tell yes all the fuses seem to be good but I'm not sure of how to do any type of multimeter tests to be sure of that cuz I was also thinking of a short Sent from my moto g(6) using Tapatalk
  18. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    What confuses me the most is what would go bad just by shutting off the truck no warning signs nothing ran great Sent from my moto g(6) using Tapatalk
  19. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    Replaced map believe they did away with egr with the vvt engine. Sent from my moto g(6) using Tapatalk
  20. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    I was also thinking that, but the brains at ram didn't put a schrader valve on the lines. It kicks on and I can smell it in the exhaust believe it is getting too much.
  21. Shortbus 50

    2015 5.7 8 speed Hard to start very rough idle...please help if you can

    I will start by warning I suck at typing fast, and am very ADHD but will do my best. Ok...got this truck from dealer with 114000 miles on it. Talked to a few guys I knew personally and they had very little issues. I got hit with a cursed b!#ch. At 124000 I got the misfire cylinder 3, did a few...
  22. Shortbus 50

    Starting issues

    So what was the issue, mine is doing the same thing. No warranty.
  23. Shortbus 50

    How-To: 4th gen hemi cam installation

    Hopefully I am asking in the correct spot... But could someone help a bit more with where to find the best cam and lifter replacement for a 2015 sport 5.7 that isnt a mopar part? I found the mds delete kit on one site, I'm just not sure what to do, way too many options. I am happy with the power...
  24. Shortbus 50

    Another TPMS Question....

    Good point. The only reason I believed them was he actually showed me the tester for those in tire sensors. But I wouldn't be surprised if it was a fluke and the sensor is bad. But most places will not pass up $120 addition when they are replacing the tires anyhow. The other strange thing is...
  25. Shortbus 50

    Another TPMS Question....

    Hey guy's. I will have to admit this is my first forum I have joined. I tried to find the answer to this question in past forums, but no luck. I have a 2015 Sport Crew Cab. My driver front tire shows a dash/line. I just had 4 new tires put on and the guys there said the part in the tire was...
Top