I’ve got the cab lights to power running lights.
Im going to run the puddle lights off if the footwell light circuit.
Lastly, I am looking for a place INSIDE THE CAB where I can tap into the signal lights.
Anyone know of a spot?
Sent from my iPhone using Tapatalk
I hate to ask Jimmy but there is a second 10 pin connector on these mirrors (it’s white). Would you be able to get that as well?
It only has two wires on it.
Sent from my iPhone using Tapatalk
You are awesome Jimmy!
I’ll let you guys know how I make out.
Does anyone know if these lights will take a full 12v, I see some of the pins are 5v
Sent from my iPhone using Tapatalk
I got around to putting the mirrors in yesterday but I can't figure out which pin is ground and which needs 12v for the running lights and puddle lights.
Does anyone have a pinout for the mirror connector?
I have purchased a set of power mirrors with puddle light and signal led.
They are installed in a 2014 Tradesman with manual locks/windows.
I have no door modules. I am looking to get 12v to the LED and the puddle lights but I need a pin out for this connector. I have scoured the web and...
Ok guys...
So dealer says there were some “erroneous codes” they checked the antifreeze with a refractometer, and verified that it was at the proper level.
Then cleared the codes HAHAHAHAH
they said if it comes back I will need a thermostat but they are backordered for months.
Basically they...
Thanks Rick, I figured as much.
I really want the running lights on the mirrors so that folks can see them sticking out at night. I think I’m going to get one of the cheaper sets off of eBay and tap the 12v from my cab lights wire
I don’t care so much about the signals. Pulling from the the...
Hey guys! I am looking for some help with this project.
I have a bare bones tradesman meaning no power in the doors aside from the speaker, temp sensor, and air bad sensor.
I want to add the puddle/running lights.
Are the door modules a necessity or can I tap into 12v somewhere and bring it...
I’ve tried to get through that thread several times... it’s 164 pages.
I get how to locate wiring for compas under the headlight switch and see the pigtail part number posted.
I am curious what you used for the other connectors on the console like the map lights and led light.
Sent from my...
Hey guys, I know this has been brought up before but I just had the check ETC message come up on my cluster with a lightning bolt and check engine symbol.
This is a 2014 RAM Tradesman 4X4 with 6.4L and 48k miles.
So far, no noticeable loss in performance.
I ran the codes with my scan tool and...
+1 request for a forum member to make the harness.
I just picked up a console from another forum member. Getting 12v to the lights seems easy enough but the compass module is where I am confused.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.