Search results
-
W
Swap electric windows out for manual?
Is it possible to swap out electric windows for manual on a 97 2500? If so how hard is it? Thanks all- wrenchinup
- Thread
- Replies: 3
- Forum: Interior
-
W
How to disconnect fuel lines at tank?
97 diesel, can’t figure out how to disconnect the fuel lines at the fuel tank, one guy said to push two clips in at the line side and with other hand pull the line back but I don’t see the two tabs and can’t fit both hands in there. Any suggestion greatly appreciated. Is there a special tool for...- wrenchinup
- Thread
- Replies: 2
- Forum: 2nd Gen DIY
-
W
Bleeding ABS controller
I put a new master brake cylinder in my 97 diesel ram. The ABS controller isnt letting much fluid through, making bleeding hard so I took it out and will probably put a pipe in it’s place. So if anybody knows if any problem that might result from that I’d appreciate the advice. I got fluid to...- wrenchinup
- Thread
- brakes
- Replies: 7
- Forum: General Discussion
-
W
vibration feels like hubs are stuck in
On the highway my 97 4 WD 2500 feels like the hubs are stuck in, when in two high, so I jacked it up and found both wheels are not freewheeling. They aren't turning. So I'm pretty sure they are stuck in, but I've never had a "Center Axle Disconnect" front axle before so I'm not positive. From...- wrenchinup
- Thread
- Replies: 1
- Forum: General Discussion
-
W
how to tell if hubs are stuck engaged 97 2500
Getting a lot of vibration on the highway like maybe the hubs are engaged. I jacked up both wheels (one at a time) and both felt tight, U joints looked good. But going down the highway in 2 wheel high it feels like my hubs are engaged. All the locking hubs I've ever had would leave the wheels...- wrenchinup
- Thread
- Replies: 8
- Forum: General Discussions
-
W
Changing fuel sending unit after I run out of fuel
Have a 97 Cummins, runs good, new fuel pump, dead fuel sender unit, and I want to empty the fuel tank the easy way, run out of fuel, so I can r and r the sending unit. but just wonder if it might cause problems. Been driving with a couple gallons of diesel in the box planning on cracking the...- wrenchinup
- Thread
- Replies: 2
- Forum: General Discussion
-
W
47RH and NV4500 swap
After I replaced my wrecked DLD transfer case with a DHD transfer case, I found that the driveshaft ( regular cab one-piece shaft) could barely fit in. It drives OK for now but there's no room for movement. So I want to shorten the shaft but I'm also thinking I might swap my 47RH auto tranny...- wrenchinup
- Thread
- driveshaft length length of 47rh nv4500 swap
- Replies: 0
- Forum: General Discussion
-
W
Running wire from tow package dead
My 1997 trailer package brown running wire going to the plug-in is out. It comes out of the factory harness, goes through the bumper. I know that the trailer wires are all independent from the truck tail lights. I'm getting the wiring diagram tomorrow but meanwhile was wondering if anybody...- wrenchinup
- Thread
- Replies: 5
- Forum: Audio & Electronics
Members online
- jawzs2
- JungleRat
- Pigster
- Dodge 1500 4X4
- rule18
- Fritter
- Docwagon1776
- GTyankee
- sigfla
- CanuckRam1313
- thkbaron
- JimJam300
- zstroken
- 56PW17
- hwood
- abates362
- StateOfMind
- crackerjack1957
- mikeru
- Daw14
- Jeepwalker
- Dutra
- Atcer2018
- Warlock656
- mtofell
- justinsierra
- bbykes
- DeckArtist
- AZ MARK
- Recon5869
- shakey32
- Afranky80
- Ducatidom
- POPS 57
- Dinky
- smoothee
- Jbg3
- HydroTopzz
- JohnCA
- Musky Mike
- RebelShortbed
- KalboKalbs
- TC
- ecsaltz