timing misalignment
-
D
2015 5.7l Hemi, Which Timing Is Right? (If either)
2015 Ram 1500 5.7 Hemi. Did a cam / lifter swap, non MDS Stock spec cam from AMS racing. Everything went in great, after setting timing ( what i thought was correct ) engine started and ran fine but Autel was reading two small misfires on cylinder 3 and 7. Thought it was pushrods misaligned but...- DodgeWTF
- Thread
- timing timing chain timing misalignment
- Replies: 3
- Forum: Engine & Performance
-
J
2016 Ram 3.6 liter P0016 & P0017 codes - help?
Need help to resolve these codes in 3.6 liter. Is there a Cam/Crank relearn process that applies with cam swap? Other causes? Could my timing chain bank 1 be stretched. Background - changed cylinder 3 rockers to try to resolve P0303 misfire code (now fixed). But I incorrectly installed cam...- Joeyboat
- Thread
- 3.6 rocker arms 3.6l cam cam crank relearn p0016 p0017 ram 3.6 l timing misalignment vvt phaser
- Replies: 1
- Forum: V6 Engine & Performance
-
G
P0016 4.7 already replaced that?
Ok so I’m at the point of using my full coverage to get my money back, I bought a 09 ram 1500 4.7L 4x4 two weeks ago, was told it jumped time and had everything replaced top end. Checked it and it had three codes being thrown. P0016 p0405 and a misfire cylinder 6. I cleared the codes and misfire...- Guywithatruck
- Thread
- 4.7 litre help please timing misalignment
- Replies: 0
- Forum: General Discussions
-
B
2019 1500 BigHorn hemi won’t idle
I had a cam shaft that eroded and was misfiring. after replacing the cam, lifters, and the timing chain I had gotten the misfire to go away. started it up and it had some obvious issues (Rough idle, sputtering rpm, died after a few seconds). I assumed I had made a timing mistake so I took the...- BigOlKy
- Thread
- hemi 5.7 ruff starting idle timing chain timing misalignment
- Replies: 7
- Forum: General Discussions
-
Accidentally misaligned cam and crank... Please help
2014 Ram 1500 Sport 5.7L After replacing the camshaft and lifters my truck a few months ago I was going into limp mode, but only when the engine was cold. I checked the computer and it showed codes P0016, P000B and the timing changing between -13 and -16° off. The engine ran fine other than the...- Manual Gen 4 Ram
- Thread
- 5.7 camshaft 5.7 hemi 5.7 hemi v8 cam and lifters cam swap camshaft replacement crankshaft timing timing misalignment
- Replies: 7
- Forum: Engine & Performance
-
W
P0016 Crank/Cam on a new rebuilt engine
2011 Ram 5.7 engine scrubbed rollers and cam. Professional rebuild. New crankshaft and cam sensors, new phazers. On initial startup it ran like a new one. Ran to Operating temp then shutdown to cool and check all fluids and leak check, All perfect. Restart let run 20 minutes again then took...- Wi Dave
- Thread
- camshaft sensor crankshaft sensor timing misalignment
- Replies: 3
- Forum: Engine & Performance
