nick_si
Member
- Joined
- Jul 10, 2013
- Posts
- 57
- Reaction score
- 4
- Location
- Portland, Oregon
- Ram Year
- 2013 Ram SLT
- Engine
- 5.7
So I have posted this on HID planet but I am not sure how many people are memebers there so I will post it up here. I will also soon be installing my 10" 3D led light bars. Enjoy.
So after a couple months of deciding if I wanted to do another retro I finally went for it again #6 now. I was going to go with the fx-r again but I was unsure of how much room was in the ebay projector housing so to play it safe I went with the MH1. Took me an hour to decide If I should JB weld them into place or create a plate. Since I wanted to have the ability to go into reverse I went with the plate. I just guessed most of this as I went and I was amazed that the cutoff was perfectly even, as for the next light I will need to make it perfect. Here are a few randoms of the process its not too detailed you can see that it can be done. The ebay projector is HUGE and I was impressed by CCFL.
So after a couple months of deciding if I wanted to do another retro I finally went for it again #6 now. I was going to go with the fx-r again but I was unsure of how much room was in the ebay projector housing so to play it safe I went with the MH1. Took me an hour to decide If I should JB weld them into place or create a plate. Since I wanted to have the ability to go into reverse I went with the plate. I just guessed most of this as I went and I was amazed that the cutoff was perfectly even, as for the next light I will need to make it perfect. Here are a few randoms of the process its not too detailed you can see that it can be done. The ebay projector is HUGE and I was impressed by CCFL.