Charlie Evans
Junior Member
Hey fellow Rammers.
I need some advice please. I finally broke down and swapped out my O2 sensors in my 08 Ram 1500. Before the swap I was getting no codes, now after changing them I started getting:
P0132 O2 sensor 1/1 circuit high,
P0138 O2 sensor 1/2 circuit high,
P0152 O2 sensor 2/1 circuit high,
P0158 O2 sensor 1/2 circuit high.
I tried to reset the codes and turned it on and off like 50 times codes still there. Today I drove it 100 miles and check engine light went off at a stop. Started it back up and started driving home and it came back on again. But now I have all of the above and
P1128 closed loop fueling not achieved bank 1
P0300 cylinder misfire faul detected random cylinders.
Any ideas where I should start looking?
Did I not torque em down enough? Was told 25ft lbs
Like I said before the swap I had no error codes.
Thanks for any advice guys (and/or gals)
I need some advice please. I finally broke down and swapped out my O2 sensors in my 08 Ram 1500. Before the swap I was getting no codes, now after changing them I started getting:
P0132 O2 sensor 1/1 circuit high,
P0138 O2 sensor 1/2 circuit high,
P0152 O2 sensor 2/1 circuit high,
P0158 O2 sensor 1/2 circuit high.
I tried to reset the codes and turned it on and off like 50 times codes still there. Today I drove it 100 miles and check engine light went off at a stop. Started it back up and started driving home and it came back on again. But now I have all of the above and
P1128 closed loop fueling not achieved bank 1
P0300 cylinder misfire faul detected random cylinders.
Any ideas where I should start looking?
Did I not torque em down enough? Was told 25ft lbs
Like I said before the swap I had no error codes.
Thanks for any advice guys (and/or gals)