Coolant Temperature Rises - 2017 Ram 1500 3.6L

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

2017RamV6GaLo79

Junior Member
Joined
Oct 8, 2026
Posts
6
Reaction score
3
Location
Texas
Ram Year
2017
Engine
3.6L Pentastar
Good morning, everyone!

I hope someone can help me with a concern I have regarding my 2017 Ram 1500 3.6L.

When driving my truck, whether on the highway, on main roads, or simply around town, the temperature displayed on the dashboard stays between 194°F and 196°F.

However, when I come to a stop in traffic for a few moments, the temperature starts rising to 226°F–230°F. At that point, the cooling fan kicks in and brings the temperature back down to around 217°F–221°F.

After a little while, the temperature starts climbing again to 226°F–230°F, and the same cycle repeats.

I'd also like to mention that the temperature gauge on the dashboard never goes above the halfway mark. It stays right in the middle the entire time.

This continues until traffic starts moving again and I can drive at a higher speed, at which point the temperature drops back down to 194°F–196°F.

I also have the Active Grille Shutters (AGS) disabled, although I'm not sure if this could be relevant.

My questions are:

Is this temperature behavior normal for this engine?

If it's not normal, what would you recommend checking or replacing?

Could the cooling fan activation temperature or the disabled AGS system have anything to do with this?

I'd really appreciate any advice or recommendations from anyone who has experienced something similar.

Thanks in advance for your help!
 

Mojo88

Senior Member
Joined
Feb 4, 2024
Posts
861
Reaction score
2,293
Location
Rhode Island
Ram Year
'19 Longhorn Gen5 ORG
Engine
Hemi 5.7L non-eTorque
Basically normal temps. How did you 'disable' the AGS? If the AGS are staying closed, then that will spike your temps for sure.

In my 2019 5.7L, the AGS are dependent upon the fan settings. I have a PWM fan only, no mechanical fan. I have adjusted the fan settings in the tune (using HPtuners) a few different times, and the AGS will always open shortly after the PWM fan comes on.

If you can get into the tune, then simply adjust fan settings to come on earlier, also install lower temp thermostat (185*), and make sure AGS opening slightly after fan comes on. That will cure your high temps, barring any other issues.
 

Yardbird

Senior Member
Joined
Aug 6, 2022
Posts
1,265
Reaction score
2,971
Location
Western NC
Ram Year
2018
Engine
3.6
That's pretty much normal. Make sure the shutters are open, or better yet, remove all but the upper and lower slats. Make sure bugs aren't plugging up the cooling fins, and that's about it.

Mine has to idle several minutes to climb like that unless it's quite hot outside and/or I've been in stop and go traffic.

Really disgusting they allow an aluminum engine to expand and contract with that big of a heat swing.

My needle doesn't move hardly, if any, when doing this also.

I was supposed to go have mine custom tuned in September to stop this foolishness, but haven't gotten around to it yet.

I have a long list of things I want changed, such as when the fan comes on when the A/C compressor is running, idle speed, immediate race to 1500+ upon ice cold startup, ect.....
 
OP
OP
2

2017RamV6GaLo79

Junior Member
Joined
Oct 8, 2026
Posts
6
Reaction score
3
Location
Texas
Ram Year
2017
Engine
3.6L Pentastar
Basically normal temps. How did you 'disable' the AGS? If the AGS are staying closed, then that will spike your temps for sure.

In my 2019 5.7L, the AGS are dependent upon the fan settings. I have a PWM fan only, no mechanical fan. I have adjusted the fan settings in the tune (using HPtuners) a few different times, and the AGS will always open shortly after the PWM fan comes on.

If you can get into the tune, then simply adjust fan settings to come on earlier, also install lower temp thermostat (185*), and make sure AGS opening slightly after fan comes on. That will cure your high temps, barring any other issues.
I removed the AGS shutters, and a guy helped me use some software to disable the check engine light and prevent the AGS-related trouble code from showing up. However, I honestly don't know what software he used or exactly what he did. He just took care of it for me.

I also don't have access to HP Tuners, and to be honest, I'm not even familiar with that software.

This is my first Ram truck. Before starting a family, I used to drive a Honda Civic, but I needed something with more room, so I decided to get the Ram.

What really concerned me was seeing those temperatures because a friend told me they were too high. However, I'm not entirely sure since he's more of a Chevy guy. He's not an expert on Rams, so he was just giving me his opinion.

I'm simply trying to figure out if these temperatures are actually normal for my truck or if I should be concerned about something.
 
OP
OP
2

2017RamV6GaLo79

Junior Member
Joined
Oct 8, 2026
Posts
6
Reaction score
3
Location
Texas
Ram Year
2017
Engine
3.6L Pentastar
That's pretty much normal. Make sure the shutters are open, or better yet, remove all but the upper and lower slats. Make sure bugs aren't plugging up the cooling fins, and that's about it.

Mine has to idle several minutes to climb like that unless it's quite hot outside and/or I've been in stop and go traffic.

Really disgusting they allow an aluminum engine to expand and contract with that big of a heat swing.

My needle doesn't move hardly, if any, when doing this also.

I was supposed to go have mine custom tuned in September to stop this foolishness, but haven't gotten around to it yet.

I have a long list of things I want changed, such as when the fan comes on when the A/C compressor is running, idle speed, immediate race to 1500+ upon ice cold startup, ect.....
Thanks... for your reply... I purchase this truck... just a few weeks ago, so I knowing how it works..
 

Mojo88

Senior Member
Joined
Feb 4, 2024
Posts
861
Reaction score
2,293
Location
Rhode Island
Ram Year
'19 Longhorn Gen5 ORG
Engine
Hemi 5.7L non-eTorque
I removed the AGS shutters, and a guy helped me use some software to disable the check engine light and prevent the AGS-related trouble code from showing up. However, I honestly don't know what software he used or exactly what he did. He just took care of it for me......

Maybe that same guy can adjust the fan settings lower for you??? If he did that, and you installed a 185* stat, your temp issues would end.
 

Yardbird

Senior Member
Joined
Aug 6, 2022
Posts
1,265
Reaction score
2,971
Location
Western NC
Ram Year
2018
Engine
3.6
Thanks... for your reply... I purchase this truck... just a few weeks ago, so I knowing how it works..


After 4 1/2 years of owning this truck, the temperature swings still drive me crazy...

Luckily, it doesn't happen very often where and how I drive.
 

Forum statistics

Threads
213,351
Posts
3,092,107
Members
174,571
Latest member
Lubrecon
Back
Top