BudsRam
Member
- Joined
- Aug 11, 2018
- Posts
- 57
- Reaction score
- 20
- Location
- Fayetteville, NC
- Ram Year
- 2015 Ram 1500 Big Horn
- Engine
- Pentastar 3.6
Hey All,
This past Wednesday...my day off... I decided to remove my drop in liner and scuff up the bed and put two coats of undercoat as some preventative maintenance against rust under the drop in liner in the future. Anyhoo, I believe I found the wires that run to the camera in my rear bumper...they were run up thru the rear left hand side "pillar" and fed into the bed just below the tie down hole. I couldn't make out the labeling on all three wires but one was labeled G and one was marked "ome"(i think).
Can anyone tell me how/where to run these to the cab to maybe get the camera working?
Thanks in Advance!
Bud
This past Wednesday...my day off... I decided to remove my drop in liner and scuff up the bed and put two coats of undercoat as some preventative maintenance against rust under the drop in liner in the future. Anyhoo, I believe I found the wires that run to the camera in my rear bumper...they were run up thru the rear left hand side "pillar" and fed into the bed just below the tie down hole. I couldn't make out the labeling on all three wires but one was labeled G and one was marked "ome"(i think).
Can anyone tell me how/where to run these to the cab to maybe get the camera working?
Thanks in Advance!
Bud
