FS: $1400 NEW ARH Headers 09-14 Hemi

[BLKSHP]

**These are for the 8-Spd transmission**

I have new in the box longtube headers from ARH. Purchased these from Moe's Performance last summer and sat in my basement since. Has the high flow cats and stainless 1-3/4 tubing.

Nearly $1700 new, asking $1400 plus shipping (figure $75-100ish as it's a big heavy box).

ARH Stainless Longtubes 2009-2014 5.7L Hemi 1 3/4" Primaries with Cats

I opened the box to confirm contents and that was it.
https://www.dropbox.com/s/mfg2nfzp30dt837/2015-02-13 06.17.43.jpg?dl=0

Thanks for looking.

 

[doz]

Just for reference, this should be for 6 speed only correct? Some people are unaware that 6 and 8 speed y-pipes are different.

 

[BLKSHP]

Just for reference, this should be for 6 speed only correct? Some people are unaware that 6 and 8 speed y-pipes are different.

Good point, no this is for the 8-Speed transmission.

 

[z28th1s]

Good point, no this is for the 8-Speed transmission.

Where are you located?

 

[BLKSHP]

I'm in the KC Metro area. Olathe, KS.

 

[jcat]

Good point, no this is for the 8-Speed transmission.

Then they are only for 13-15 hemi, not 09-14 as you have them listed.

 

[BLKSHP]

Edit top post to note this. Will consider reasonable offers to move this out.

 

[Pull Ya]

Have these been coated? Will need to talk to Matt about the difference in the 6 speed and the 8 speed configuration regarding the Y pipe.
Jay

 

[BLKSHP]

No not coated. Was quoted $300 to do it FWIW.

 

[surfinca79]

Are these 50 state legal, I'm in California.

 

[BLKSHP]

Are these 50 state legal, I'm in California.

No idea and Moes site doesn't say. They have high flow cats, so there's a chance they are legal.

 

[VPRPWRD]

PM sent.

 

[doz]

Have these been coated? Will need to talk to Matt about the difference in the 6 speed and the 8 speed configuration regarding the Y pipe.
Jay

The 8 speed y-pipe should fit a 6 speed but a 6 speed wont fit an 8 speed.

I had the issue where I received a 6 speed y-pipe (seller stated it was 8 speed, turns out it was not) and tried to install on an 8 speed. It touches the transmission pan. I actually had to dent in the pipe a little to get it to clear till I got a new y-pipe.

 

[Pull Ya]

Thanks doz
Jay

 

[JJK]

Headers

I will take them! if there still available.....

 

[BLKSHP]

Payment received and sold.