pro comp 6 inch lift issues

[qman]

i have a 6 inch pro comp lift kit with coilover strut assembly.(no strut spacer) the top of the strut where the mono ball is located is hitting the one side of the top strut bracket. in the picture you can see the left is making contact. does anybody else have this issue.
pro comp says it's definitely not sitting right but there trying to blame my control arms for the problem. not cool since the problem existed before i even replaced the control arms. any suggestions or advice would be great and if anybody can recommend a better strut assembly that would be great too.

 

[JB1]

There should be a mono ball spacer on each side of that upper shock mount, yours may be worn down or missing.

Fox makes a full length coilover for 6” kits (used on BDS) and Dirt Logic also makes one (used on fabtech)