Question after Zone install

Williams3803 · Feb 15, 2017

So I got the zone 6 inch lift with 5 inch springs, rear fox 2.0 shocks, and bilsteins at 2.8 up front. I still have about an inch rake and really like the leveled look better. Is there any way to level it at this point?? I really couldn't find anything after searching the forum. Thanks guys. Measurements are 44.5 inches up front and rear 45.5.

Marciel · Feb 15, 2017

Guess that's the only drawback of not having a threaded coilover, not as much fine tuning in ride height.

Sent from my SM-N910V using Tapatalk

Williams3803 · Feb 15, 2017

I don't think they make a cool over that can adjust that much though. I would buy them if I could find some.

Marciel · Feb 15, 2017

Fabtech and fox make ones specific for a 6" lift. I run my dirt logics really low in the threads but there is way more lift if I wanted.

Sent from my SM-N910V using Tapatalk

reddevil78 · Feb 15, 2017

If the lifts brand new let it settle. Maybe you'll level out or be closer to your mark, and it won't look as noticeable.

Scgirardi · Feb 16, 2017

Find a fab shop and cut rear springs. Buddy at work had that done due to his zone lift having rake. It actually had more rake as time went on due to a lot less weight in the rear of the truck.

Question after Zone install

Williams3803

Junior Member

Marciel

Senior Member

Williams3803

Junior Member

Marciel

Senior Member

reddevil78

Senior Member

Scgirardi

Senior Member

Similar threads

Latest posts

Members online

Forum statistics

Share this page