Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
If you're talking about the jumpseat they're 13mm.
I bought one with a CD player compartment. Both are the jump seat type setup.
No I need the size that hold the Center Console in place, two rear bolts and two front bolts. I believe then it's two Philip screws and unplug the electronic connection by driver seat.
In order to remove the center seat, you must remove 4 13mm bolts, then you can remove the brackets.
I'll need a picture to visualize what you're talking about.
Are you putting in a full center console or are you putting in a jumpseat console?Mine came with two brackets
One directly below bezel the other where old jump seat console was ?
Sent from my iPhone using Tapatalk
Mine came with two brackets
One directly below bezel the other where old jump seat console was ?
Sent from my iPhone using Tapatalk
Sorry I can't help you there. My earlier comment was in reference to the jumpseat only. I replaced my jumpseat with one that had the lower storage compartment/CD player.
Here are some pics from my swap.
After you remove the forward lower storage tray, the front bracket will bolt on to the dash. There are allignment holes on the bracket that line up with dowels on the dash. You will need 2 bolts, 2 nuts, and some fender washers to bolt the forward bracket on. As far as the 4 bolts that hold the console to the brackets, I believe they are m6 x 1.25.
