Steen
Senior Member
- Joined
- Dec 22, 2013
- Posts
- 112
- Reaction score
- 20
- Location
- Weeki Wachee
- Ram Year
- 2016 Big Horn Crew Cab 1500
- Engine
- Hemi 5.7
Guys,
Been searching on this topic for the past two days. Need to narrow it down to hopefully someone that has experienced not only the same thing, but in the same vehicle.
I am trying to resolve an extremely frustrating situation. I have a 2008 Dodge Ram with the Infinity Speaker Package. Installed the radio with the suggested CHTO-013BB from Best Buy. Installed all the wired connections per the Axxess instructions and the Kenwood DDX470 installation manual. Once installed the head unit powers on, but I get no sound from any source (Radio, CD, Bluetooth, Aux, etc.), even no touch screen selection beeps from the head unit. After my discovery, I reinstalled the stock unit and all works as it should. My conclusion is that I am not getting a proper AMP-TURN ON signal to the factory amps which is exactly why I bought the CHTO-013BB. When looking at the stock wiring diagram (attached), I appears that the CHTO-013BB sends a signal through the rear speakers outputs? Is that correct? Is the factory remote turn on signal from the CAN-BUS+ (pin 5)? There is nothing hooked to that wire from the CHTO-013BB.
I’ve attached some pictures for reference. Has anyone come across this problem yet?
Been searching on this topic for the past two days. Need to narrow it down to hopefully someone that has experienced not only the same thing, but in the same vehicle.
I am trying to resolve an extremely frustrating situation. I have a 2008 Dodge Ram with the Infinity Speaker Package. Installed the radio with the suggested CHTO-013BB from Best Buy. Installed all the wired connections per the Axxess instructions and the Kenwood DDX470 installation manual. Once installed the head unit powers on, but I get no sound from any source (Radio, CD, Bluetooth, Aux, etc.), even no touch screen selection beeps from the head unit. After my discovery, I reinstalled the stock unit and all works as it should. My conclusion is that I am not getting a proper AMP-TURN ON signal to the factory amps which is exactly why I bought the CHTO-013BB. When looking at the stock wiring diagram (attached), I appears that the CHTO-013BB sends a signal through the rear speakers outputs? Is that correct? Is the factory remote turn on signal from the CAN-BUS+ (pin 5)? There is nothing hooked to that wire from the CHTO-013BB.
I’ve attached some pictures for reference. Has anyone come across this problem yet?