R/T_Fire
Senior Member
- Joined
- Feb 3, 2015
- Posts
- 3,432
- Reaction score
- 1,205
- Location
- Pleasant Grove
- Ram Year
- 2011
- Engine
- Hemi 5.7
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Belltech street performance shocks. The replacement ones are s slightly different design and about 1/2" longer so i fear they will cause more issues....Dang, what drop and shock?
Its just a spring drop... that honestly needs to go. I didnt set it up this way. Bought the truck from a dealer already dropped. This winter i think ill start in on the inez and coilover part to my build. Depends on what is in the budget after i finish the 88 k5 LQ4 engine swap and 1 ton build... its in the midst of a frame off build and once that is done the ram is next.Are you running a spindle drop? Or jus springs and shocks out front?
Sent from my iPhone using Tapatalk
I think your right, i think i have a cup type spacer design for the bottom of the arm to make up the difference to not punch out the bottom again... temp fix till i get the inez arms and coilovers ordered and brackets designed and fab'dShocks bottoming out would be my bet. I’ve been running a spindle drop for 4 years on factory shocks. And haven’t had a bit of trouble
Sent from my iPhone using Tapatalk
I think your right, i think i have a cup type spacer design for the bottom of the arm to make up the difference to not punch out the bottom again... temp fix till i get the inez arms and coilovers ordered and brackets designed and fab'd
Sent from my SM-G920V using Tapatalk
Order???? I'll be builing all the mounts myself. Not sure if you meant shock eyelets or fram mounts?You should be good to go. Order the mounts heavier built than what you actually need. Would be my only thoughts though.
Sent from my iPhone using Tapatalk
I want to drop our charger, but im afraid to. I want a 275 rear and about 1" to 1.5" drop on it.... its already so damn low. But i found a adjustible coilover kit for that for 1ki can kinda relate. My car is lower than the normal chargers and coming from a leveled ram. Its hard to remember that Im low. Most angles my front lip will hit(need better front protection) also going over speed bumps can be a challenge. I get front wheels over then sometimes scrape the exhaust.
Order???? I'll be builing all the mounts myself. Not sure if you meant shock eyelets or fram mounts?
Sent from my SM-G920V using Tapatalk
Exactly my plan since i plan to road course itSorry. Didn’t see you was building the mounts. Since your going that route. Order the shocks as heavy built as possible. Just my thoughts. So you can beef the mounts up alittle more.
Sent from my iPhone using Tapatalk