GoGoGadgetJimbo
Junior Member
First Post
I've been going through the forum for info on my issue for the last week.
Truck has been fine. Started missing (P0300, p0301-307).
Replaced all ignition components (plugs, wires, cap, rotor, coil). After doing this, the engine only throws a code if i try and floor the engine. Only throws P0300-P0307.
Engine, once warm revs up quick to 3,000-3,500 rpms, but tops out there. Cold, doesn't seem to have as much of an issue, but seems a bit sluggish. No miss that i can hear on idle.
All around the engine seems to have no power.
Limited tests I've done (I'm broke until next week)
Injectors show 12.5K ohms across connector tabs.
No arcing sparks to block
No vacuum leaks i can find.
Other random info:
No vacuum leaks
Passenger side valve cover shows no vacuum (finger test)
Drivers side valve cover shows vacuum
Peering in the throttle body, intake looks pretty clean
Plugs come out clean
I haven't done a compression test yet, I know someone will ask
I've been going through the forum for info on my issue for the last week.
Truck has been fine. Started missing (P0300, p0301-307).
Replaced all ignition components (plugs, wires, cap, rotor, coil). After doing this, the engine only throws a code if i try and floor the engine. Only throws P0300-P0307.
Engine, once warm revs up quick to 3,000-3,500 rpms, but tops out there. Cold, doesn't seem to have as much of an issue, but seems a bit sluggish. No miss that i can hear on idle.
All around the engine seems to have no power.
Limited tests I've done (I'm broke until next week)
Injectors show 12.5K ohms across connector tabs.
No arcing sparks to block
No vacuum leaks i can find.
Other random info:
No vacuum leaks
Passenger side valve cover shows no vacuum (finger test)
Drivers side valve cover shows vacuum
Peering in the throttle body, intake looks pretty clean
Plugs come out clean
I haven't done a compression test yet, I know someone will ask