Recent content by LilredHemi
-
LED Tail Lights - Resistors Needed?
Answered my own question! I installed a second set of resistors on the brake lights and now all is good. No more hyper-flashing or lamp out indications.- LilredHemi
- Post #22
- Forum: Audio & Electronics
-
Trans upgrade
Thanks for the insight! Gives me something to think about! Was the dash conversion difficult or were the cabs similar enough to make it doable?- LilredHemi
- Post #3
- Forum: Engine & Performance
-
Trans upgrade
Has anyone swapped in the later model 6 speed trans or know if its possible to do so? Would I be better off swapping in an entire 6.4l and trans combo? I currently have an 05 5.7 4x4 Laramie. Tia for any help/suggestions!- LilredHemi
- Thread
- engine swap. trans swap
- Replies: 3
- Forum: Engine & Performance
-
Oil filter relocation kit
Caution before you buy! 5.7 Hemis use a 3/4 x 16 thread size and 6.4s use a 22mm x 1.5 thread. I work for Napa and we carry an ATP 18428 remote filter kit. I will check tomorrow if it will support the smaller 6.4 filter size. Anyone note: The Wix 51515R filter is a RACING filter and IS NOT...- LilredHemi
- Post #14
- Forum: Heavy Duty
-
LED Tail Lights - Resistors Needed?
I have these taillights on my 05 Ram 1500 Laramie. When I initially got them and plugged them in they didn't work. I found that the ground wires in the connectors had no pins to mate with the ground connection in the truck connector! I found a set of extension cables on Amazon and was able to...- LilredHemi
- Post #21
- Forum: Audio & Electronics
Members online
- sflub
- TC
- aszumilo
- MethrenUnede
- Plattidaddy
- Daw14
- Dan Topp
- mrack
- skates15
- heathric79
- golfer99
- CanRebel
- Phrede
- DURASPANK
- victor26
- clay282
- icetraxx
- Josh1988
- Poram
- EveryoneIsAnother
- Bubbaj1s
- bxbricky
- 97RedRam
- mastaP
- DReinke
- t-w-i-a
- rule18
- jabartram
- NETim
- Hanover Fiste
- Jass Dhaliwal
- RickeyB
- Arkweldr
- OC455
- ler33
- Brads41789
- dogman1911
- G-Ride990
- shopman
- enuser
- qlesage