yea its barely touching... the kit was a very tight fit for the shop and at first i had 5 inch tips which pushed up on it hard, so i threw the 4 inch tips that came with the kit back on. nothing has melted or anything.
so for a 5.5 inch lift and my 37x13.5x22, i needed to trim the very corner on each side of the front valance, but also remove those plastic tiny spat guards that come on the cab corners
just got her home on sunday! 5.5 inch BDS with 37x22x13.5 nitto ridge graps, TIS 22x12 547B. Drives like a dream! rubbed on those tiny little spat guards on front cab corner, and the very tip of the front valance.
Factory backspacing will most likely require some trimming and depending on the lift kit and how it moves the axle. look for quality like BDS or Zone they usually keep the axle centered.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.