Tach_tech
Senior Member 36
- Joined
- Last seen
- Posts
- 3,274
- Reaction score
- 3,496
Latest activity Postings About
-
-
Tach_tech replied to the thread Issues with ignition coils.Sounds like you need to get out a multimeter and a wiring diagram. Any codes being set? Could be a wiring issue, or the PCM itself. With... -
Your factory coils are better.Try re-installing the original coils,and see what happens.If your truck calls for irridium plugs ,you have...
-
Tach_tech replied to the thread 2011 5.7 With Wireless Ignition - No crank/No Start.WCM is a common failure, connections inside get loose. Try turning the key to the start position and while holding it in the start...
-
Tach_tech replied to the thread Long cranking before start..Could be fuel pump not holding pressure, leaking injectors, bad purge valve. Does it happen first start of the morning or just after it...
-
Tach_tech replied to the thread Accessing the radiator fill cap.The rad cap is on the reservoir which is located behind the air filter on the passenger side of the firewall.
-
Tach_tech replied to the thread Extended warranty for aftermarket turbo.I highly doubt you will find any aftermarket warranties that will sell You a warranty. I know whipple used to offer a optional warranty...
-
Tach_tech replied to the thread Looking for feedback ram ecodiesel Dealer experience Ormond Beach to Jax area, thx.You can refuse to have a recall performed. We used to have that happen every now and then at my dealer.
-
Tach_tech replied to the thread Should I be concerned with these idle hours?.You are actually at 27%, which is still kinda high.
-
Tach_tech replied to the thread Gas tank strap recall.It’s not just for regular cabs. The original U04 recall applies to all 2009-2012 DS trucks within the required build dates. Doesn’t...
-
Tach_tech replied to the thread Cylinder #1 misfire (P0301) and CEL, but only at 4500/5000 rpm and above.If you’ve already swapped plugs/coils then I’d swap the injector. After that, you could do compression/leak down tests. The idea that...
-
Tach_tech replied to the thread PO456 Code.Not equipped with an EGR valve. Chances are there is a leak and your mechanic just can’t find it. Purge valves are pretty common as...
-
Tach_tech replied to the thread 2013 RAM 1500 3.6L P0128.I’d probably try an OE thermostat. I do t think I’ve ever worked on a 3.6 with a P0128 that wasn’t caused by a thermostat.
-
Tach_tech replied to the thread Engine light on dealership says no codes???.Is the CEL on with the vehicle running or just key on? The only time I came across a CEL with engine running but no codes it was a...
-
Tach_tech replied to the thread Boost a Pump install, which is the Fuel Pump Power wire?.Have you data logged to see exactly when it starts building boost? You won’t get full boost right off idle. My whipple doesn’t start...
-
Nice work! I use this $7.50 cap from amazon with the T-handle. Never spilled a drop...
-
-
Loading…
-
Loading…
