Ponage
Junior Member
Hey guys,
I have a 1985 Dodge W350 with the 360 engine in it, and I am looking to swap the valve covers to some aftermarket ones like the Mopar or Edelbrock embossed ones. The concern I have, is most of these valve covers only have one hole in each. So that leaves out one valve cover component if there are only two holes. So if I just run a PCV Valve and breather, then where do I put my oil fill cap at? Do I need to have a PCV valve and breather, or just one or the other?
I have a 1985 Dodge W350 with the 360 engine in it, and I am looking to swap the valve covers to some aftermarket ones like the Mopar or Edelbrock embossed ones. The concern I have, is most of these valve covers only have one hole in each. So that leaves out one valve cover component if there are only two holes. So if I just run a PCV Valve and breather, then where do I put my oil fill cap at? Do I need to have a PCV valve and breather, or just one or the other?