The console and the center seat use different wiring harnesses. This includes the dashboard wiring harness as well. In a nutshell I did the following.
1a) Removed center seat assembly and wire harness to use with my purchased center console.
Since I didn’t take seat apart I cut
wire to center storage charge only usb -
1b) soldered wires to center console charge only usb connector
2a) Purchase 5 ft of 9 wiring from local stereo shop. - $22.00
2b) Purchased 2 mini usb female to male extenders to connect front usb assembly -13.00
2c) Extended the cd plug connector from seat wiring harness so it would reach CD player in console - extended wiring 18 inches
2d) Front plug from dash to connect power to console front usb assembly - Extended 16 inches
2e) Front 120 volt plug located on right side of dash - Extended wiring 12 inches
to connect to center console
3) Purchased 2 mini usb female to male extenders to connect front usb assembly
Soldered all wires and shrink wrap as needed-You can use butt connectors as well your choice.
4 ) Purchased front and rear brackets for console as it whereas the seat only uses 1 in the rear and bolts to floor in front which is different from console. $55.00
5) Purchased left and right small dashes covers for console $26.00
6 Cut carpet where needed to install center console.
If you swap you need to swap carpet otherwise the person with console will have a hole once seat is installed.
Total parts cost - $116.00
Console Cost —- $500.00
Total-——————$616.00
Now I have a new center black seat to sell without the harness
View attachment 195659
View attachment 195660