infernoredram
Senior Member
- Joined
- Feb 13, 2011
- Posts
- 1,122
- Reaction score
- 88
- Location
- South Texas
- Ram Year
- 2007
- Engine
- 5.9 Cummins
Is that truck 4x4? If so, that could also cause a major loss of power through the drive train
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Yesterday we had a customer do a before and after dyno with one of our new 85mm Ported Throttle Bodies. I am amazed at the results. His truck s a 2009 with a Vararam Cold air intake, Aero Turbine 3030XL Muffler, Magnaflow Y-pipe, 180* Thermostat, Diablo 93 octane tune, and an electric fan. His first pull with these mods made 301hp/325tq at the rear wheels. After this, he installed our 85mm ported throttle body which took all of 5 minutes. He made 2 more pulls and both were the same...327hp/349tq. That is a gain of 26hp/24tq at the rear wheels with a simple 5 minute modification. It doesnt get much better than that.
I told you I gained some Hp. I could feel it
Sent from my HTC Sensation 4G using Tapatalk 2
I Got mine at Moes and it,s Ok however had to remove the knife edge as the truck would stall or go into limpe mode at -10. Since these 85mm tbs are not ported straight thru i just swapped in the oem plate and was good to go. No noticeable gain in overall quickness of the truck 0-60 but a nice throttle response. A ported TB on the LX cars is a waste of dough, well thats what Stu at Inertia said when he tuned my Car.
Well, I know what's my next mod going to be now. Do you do "layaway"
What is the forum member discount on these tbs?
Sent from my ADR6400L using Tapatalk 2
I have plenty in stock, so I'm ready when you are ready.