My first mod

[fat1]

$390 at the stealership, they gave me my old fobik back but said they wont start the truck. I don't need them but they didn't get to keep them and I didn't have to do any work

 

[S2kiHemi]

Remote start. Nice!

 

[dodger2107]

I got an aftermarket viper and I love starting this thing and have it ool inside when i get in it

 

[bigbadram1500]

Sweet! remote start is so nice in the winter

 

[jojo750]

i had the dealer re-program my old fobs at the same time. so now i have 4 fobs. 2 with remote start.

 

[fat1]

Yea I uh kind of got that worked out over the phone and they'll be reprogramming the old keys for me and educating their staff for consistency. I believe my truck will be very clean and smell like fresh wax when I pick it up this time. They were very nice on the phone.

 

[quietpeen]

sweet, i love my remote start

 

[EJM05]

i love mine too

 

[LB3711]

so do I. wish I had the Auto HVAC

 

[fat1]

I do too, its killin my fuel economoy tho lol

 

[LB3711]

its a truck who cares. I use mine sometimes too much. 80 mph is the norm for me

 

[2K10HemiRam]

I wish I had remote start...one thing I keep on forgetting about when it comes to mods. Should add that to my build sheet so I don't forget anymore, haha

 

[garner]

Love my remote start and I agree about it killing gas mileage especially when it sits there idleing for like 10 minutes lol

 

[09SMOKINHEMI]

yeah, no doubt, remote starts are awesome. I like mine with the android app, where I can start it from anywhere, pretty sweet

 

[fat1]

So I made it back over to the stealership (not the point of purchase but one located near my office). I took all 4 keys and printed this excerpt from the service manual:


PROGRAMMING THE WIN
CAUTION: Read all notes and cautions for programming procedures.


1. Connect a battery charger to the vehicle.
2. Connect the scan tool.


NOTE: Have the vehicle PIN readily available before running the routine

CAUTION: If the PCM and WIN are replaced at the same time, the PCM MUST be programmed before the WIN.


3. Select “ECU View.”
4. Select “WCM”.
5. Select “Miscellaneous Functions.”
6. Select "WIN Replaced".
7. Enter the PIN when prompted.
8. Cycle ignition key after the successful routine completion.


PROGRAMMING IGNITION KEYS TO THE WIN
CAUTION: Read all notes and cautions for programming procedures.


1. Connect a battery charger to the vehicle.
2. Connect the scan tool.
3. Have a unique vehicle PIN readily available before running the routine.
4. Ignition key should be in RUN position.
5. Select “ECU View”.
6. Select “WCM Wireless Control”.
7. Select “Miscellaneous Functions.”
8. Select “Program Ignition Keys or Key FOBs”, Start
9. Enter the PIN when prompted.
10. Verify the correct information.
11. Cycle ignition key after the successful routine completion.


NOTE: If the original keys do not successfully program to the new WIN after the proper procedures are followed correctly, programming new keys will be necessary.

NOTE: A maximum of eight keys can be learned by the WIN. Once a key is learned by a WIN, that key has acquired the Secret Key for that WIN and cannot be transferred to any other vehicle.



I now have 4 keys 2 with remote start.