Need alittle help

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

ramanator

Senior Member
Joined
May 28, 2014
Posts
318
Reaction score
117
Location
alabama
Ram Year
2006, 1999, 1995, and 1984
Engine
Hemi 5.7, two 318s and a 360
What's the best way to change the crankshaft position sensor? 95 5.9 4x4
 

steermaster

Senior Member
Joined
Jan 26, 2015
Posts
188
Reaction score
33
Location
CO
Ram Year
2004
Engine
5.7L
I am not sure about the 95 but I would say contact your local dealership and ask em. Speak to the service dept and they usually will try and help you or run back and ask a mechanic on whats the route to take...GOOD LUCK!
 

BlackMagnum2000

Senior Member
Joined
Jan 9, 2014
Posts
6,145
Reaction score
2,340
Location
Locust Grove, GA
Ram Year
2000
Engine
5.9 Magnum
Take off the inner fender well on the passenger side. My dad said it's so much easier as compared to when I did mine the normal way of crawling up in the bay (it's a long story as to why he replaced my CKPS and why it was replaced twice).
 
Last edited:
OP
OP
ramanator

ramanator

Senior Member
Joined
May 28, 2014
Posts
318
Reaction score
117
Location
alabama
Ram Year
2006, 1999, 1995, and 1984
Engine
Hemi 5.7, two 318s and a 360
Thanks guys. And are you sure it's the driver side from what I've read it's on the passenger side
 
OP
OP
ramanator

ramanator

Senior Member
Joined
May 28, 2014
Posts
318
Reaction score
117
Location
alabama
Ram Year
2006, 1999, 1995, and 1984
Engine
Hemi 5.7, two 318s and a 360
No problem lol I was just making sure. I got the inner fender out yesterday and found the sensor but ran out of daylight and warmth lol
 
Back
Top