JoshR104
Senior Member
- Joined
- Oct 3, 2017
- Posts
- 581
- Reaction score
- 791
- Ram Year
- 2018
- Engine
- 6.4 Hemi
Update these have been sold.
Came off my 2018 Limited 2500. Sold the truck and cleaning out the garage only reason they were in there was because I put the morimoto xbs on it which the buyer wanted. Whole setup was run from December 2018 to August 2019 without any issues. Everything worked properly when stored in the garage.
Details in the projector and bulbs.
Low beams D2S 4.0 with XB55 ballast running their XB50 55w bulb in 5.8k
High beams have morimoto 2stroke 2.0 Leds
All parts purchased via Nick at got exhaust.
One ballast went bad within the first few weeks and was replaced with a newer style under warranty (Hence the difference in the picture)
Will include the harness and resistors as well but reccomend using alphaobd to just enable HIDs as the harness is hit or miss with the canbus systems on these trucks.
Now for the bad.. when retrofitting the top part of the passenger side came in contact with too much heat and slightly melted however its only cosmetic does not leak as I covered it with retro rubber just to be safe. The drivers side would get condensation from time to time but hadnt after I sealed it again. They were sealed with retro rubber so you can easily pop them back open. They dont look the prettiest but once mounted you cant see any of it anyways.
I have photos in my build thread with pictures of when I did it plus on the truck after in use.
Willing to ship on buyers dime as I have the morimoto packaging I can use to send you the lights in or can meet up within a reasonable distance located right by upstate NY near Binghamton.
$500 or best offer just want them gone.
Any questions ask.
Came off my 2018 Limited 2500. Sold the truck and cleaning out the garage only reason they were in there was because I put the morimoto xbs on it which the buyer wanted. Whole setup was run from December 2018 to August 2019 without any issues. Everything worked properly when stored in the garage.
Details in the projector and bulbs.
Low beams D2S 4.0 with XB55 ballast running their XB50 55w bulb in 5.8k
High beams have morimoto 2stroke 2.0 Leds
All parts purchased via Nick at got exhaust.
One ballast went bad within the first few weeks and was replaced with a newer style under warranty (Hence the difference in the picture)
Will include the harness and resistors as well but reccomend using alphaobd to just enable HIDs as the harness is hit or miss with the canbus systems on these trucks.
Now for the bad.. when retrofitting the top part of the passenger side came in contact with too much heat and slightly melted however its only cosmetic does not leak as I covered it with retro rubber just to be safe. The drivers side would get condensation from time to time but hadnt after I sealed it again. They were sealed with retro rubber so you can easily pop them back open. They dont look the prettiest but once mounted you cant see any of it anyways.
I have photos in my build thread with pictures of when I did it plus on the truck after in use.
Willing to ship on buyers dime as I have the morimoto packaging I can use to send you the lights in or can meet up within a reasonable distance located right by upstate NY near Binghamton.
$500 or best offer just want them gone.
Any questions ask.
Last edited: