Go Back   DODGE RAM FORUM - Dodge Truck Forums > Dodge Ram Generations Forum > 4th Gen : 2009 - Present > Lifted


Lifted

Can anyone show me there 4" lift on 35's?


This is a discussion on Can anyone show me there 4" lift on 35's? within the Lifted forums, part of the 4th Gen : 2009 - Present category!
Originally Posted by Solid State 6" zone w/ 5" rear, bils @ 2.1 on 35x12.5x20 toyo mts...for what its worth, ...


Like Tree19Likes

Reply
 
LinkBack Thread Tools Display Modes
Old 12-27-2016, 10:18 AM   #11 (permalink)
Senior Member
 
Join Date: Aug 2016
Location: Indiana
Posts: 199

Ram Year: 2015 Big Horn Crew Cab
Engine: Hemi 5.7
Default
Originally Posted by Solid State View Post
6" zone w/ 5" rear, bils @ 2.1 on 35x12.5x20 toyo mts...for what its worth, if you dont have any height resttictions, go with the 6" its like $100 more.
do you know your height of the truck up to the top of the shark fin (if you have one)?

Could you fit into a 7' garage door? 83"?

Love the look of your truck. I'm getting 4" BDS installed, but would rather have the 6".


Sponsored Ad
Register to remove this ad.


__________________
2015 Crew Cab Big Horn
mpittman is offline   Reply With Quote
Old 12-27-2016, 10:28 AM   #12 (permalink)
Senior Member
 
Join Date: Apr 2016
Age: 36
Posts: 328

Ram Year: 2011 Bighorn
Engine: Hemi 5.7
Default
Originally Posted by mpittman View Post
do you know your height of the truck up to the top of the shark fin (if you have one)?

Could you fit into a 7' garage door? 83"?

Love the look of your truck. I'm getting 4" BDS installed, but would rather have the 6".
So, I have kinda been following along on your posts. You seem to have similar questions that I did when I lifted my truck a few months ago. My main hang up was would it fit in my garage? My truck fits under my 7 ft door. My weather strip is @ 83". My sharkfin is aprox 1" below that. I measured probably 100x. Ultimately i cut a 7" section of 2x4 and set it on top of my truck. Drove in and out of my garage about 5x and it didnt tip over. I already had my bils on, and knew the lift would only ne another 5.5". I LOVE my 6" zone liift, and would have been wishing I got the 6, had I gone 4. That's my 2 cents
Solid State is offline   Reply With Quote
Old 12-27-2016, 10:32 AM   #13 (permalink)
Senior Member
 
Join Date: Apr 2016
Age: 36
Posts: 328

Ram Year: 2011 Bighorn
Engine: Hemi 5.7
Default
That's a nice lift, go with the 6. I have yet to see a member on here that got the 6", and wished they would have only done the 4".
Solid State is offline   Reply With Quote
Old 12-27-2016, 10:39 AM   #14 (permalink)
Member
 
Join Date: Feb 2016
Age: 29
Posts: 85

Ram Year: 2015
Engine: 5.7 Hemi
Default
Originally Posted by fastgti View Post
Attachment 81812 here is one with my trailer attached Attachment 81813


Sent from my iPhone using Tapatalk
Would the mopar oem air suspension have enough to level out your truck with your trailer?

Sent from my STV100-1 using Tapatalk
rango10 is online now   Reply With Quote
Old 12-27-2016, 10:44 AM   #15 (permalink)
 
fastgti's Avatar
Senior Member
 
Join Date: Dec 2014
Location: Augusta GA
Posts: 156

Ram Year: 2006
Engine: 5.7. hemi
Default
Originally Posted by rango10 View Post
Would the mopar oem air suspension have enough to level out your truck with your trailer?

Sent from my STV100-1 using Tapatalk


From what I am being told on the newer trucks with air ride it would level out. But mine being older I dont have air ride


Sent from my iPhone using Tapatalk
fastgti is offline   Reply With Quote
Old 12-27-2016, 10:47 AM   #16 (permalink)
 
fastgti's Avatar
Senior Member
 
Join Date: Dec 2014
Location: Augusta GA
Posts: 156

Ram Year: 2006
Engine: 5.7. hemi
Default
Shit. I did not see this was 4th gen. Sorry about that. Mines a 3rd gen


Sent from my iPhone using Tapatalk
fastgti is offline   Reply With Quote
Old 12-27-2016, 11:05 AM   #17 (permalink)
Senior Member
 
Join Date: Aug 2016
Location: Indiana
Posts: 199

Ram Year: 2015 Big Horn Crew Cab
Engine: Hemi 5.7
Default
Originally Posted by Solid State View Post
So, I have kinda been following along on your posts. You seem to have similar questions that I did when I lifted my truck a few months ago. My main hang up was would it fit in my garage? My truck fits under my 7 ft door. My weather strip is @ 83". My sharkfin is aprox 1" below that. I measured probably 100x. Ultimately i cut a 7" section of 2x4 and set it on top of my truck. Drove in and out of my garage about 5x and it didnt tip over. I already had my bils on, and knew the lift would only ne another 5.5". I LOVE my 6" zone liift, and would have been wishing I got the 6, had I gone 4. That's my 2 cents
I would love to take the leap of faith and get the 6" lift. I have done the same thing. I put 6" blocks on top of my truck and put one 9" block back near the shark fin, to simulate the extra 3" of the fin. I put all of this in the center of the truck, the highest point. All of the 6" blocks cleared with ease. The 9" block did scrape the flexible weatherstripping around the door frame, but remember, that was in the center of the cab. The top of the cab curves downward towards the sides, so the fin is actually lower on the left side. So, I feel that block would never have hit if it was actually near the fin.

I'm just too nervous to do it. I'd probably get served divorce papers if I couldn't put my brand new truck in the garage
Solid State likes this.


__________________
2015 Crew Cab Big Horn
mpittman is offline   Reply With Quote
Old 12-27-2016, 11:17 AM   #18 (permalink)
 
Orion's Avatar
Senior Member
 
Join Date: Aug 2016
Age: 18
Posts: 157

Ram Year: 2009
Engine: Hemi 5.7L
Default
I went ahead and pulled the trigger on the 7" lift lol. Rip Parking Garage
Solid State likes this.


__________________
Orion is offline   Reply With Quote
Old 12-27-2016, 11:18 AM   #19 (permalink)
 
joeygster's Avatar
Senior Member
 
Join Date: Sep 2015
Location: Ancaster, Ontario
Posts: 566

Ram Year: 2016 Ram 1500 Sport Crew Bright White
Engine: Hemi 5.7
Default
Here's my 4" Superlift with 20x9 (-12mm offset) 35's.







Synolimit and Solid State like this.


__________________
2016 Ram 1500 Sport Crew Bright White, 5.7 litre Hemi, 3.92 Axle Ratio, 4" Superlift Lift Kit, XD Rockstar 2's 20x9 (-12mm offset), 35x12.5x20 Cooper STT Pro's, Bushwacker Pocket Fender Flares, RetraxOne MX Retractable Tonneau Cover, Mopar Bedrug, DeeZee Tailgate Assist
joeygster is offline   Reply With Quote
Old 12-27-2016, 11:48 AM   #20 (permalink)
Senior Member
 
Join Date: Aug 2016
Location: Indiana
Posts: 199

Ram Year: 2015 Big Horn Crew Cab
Engine: Hemi 5.7
Default
Originally Posted by Solid State View Post
So, I have kinda been following along on your posts. You seem to have similar questions that I did when I lifted my truck a few months ago. My main hang up was would it fit in my garage? My truck fits under my 7 ft door. My weather strip is @ 83". My sharkfin is aprox 1" below that. I measured probably 100x. Ultimately i cut a 7" section of 2x4 and set it on top of my truck. Drove in and out of my garage about 5x and it didnt tip over. I already had my bils on, and knew the lift would only ne another 5.5". I LOVE my 6" zone liift, and would have been wishing I got the 6, had I gone 4. That's my 2 cents
What are your Bils set at? 1.4? 2.1? If you level at 2.1 with a 6" lift, wouldn't that give you a total raise of nearly 8" in the front? What did you do in the back? 3" , 5" ??


__________________
2015 Crew Cab Big Horn
mpittman is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Show off your 4" lift! 713Hemi Lifted 86 11-26-2015 07:31 AM
1500 2WD 3" Spindle Lift + 1.5" Rear Spring Lift sandiego74 Lifted 3 09-09-2015 11:00 AM
Looking for pics of 6" suspension lift, 3" body lift on 35" tires Thatdude596 Lifted 13 01-27-2015 06:45 AM
New to the forum, and also new to the EcoDiesel - Have a video "tour" to show it off! TSR6 Introduction 13 08-12-2014 06:59 AM
8" Full Throttle Suspension lift or 6" lift with blisteins and spacer??? nickaliRAM Lifted 15 12-13-2013 07:19 PM

<




GM Truck Forum
Ford Raptor Forum
Chevy Tahoe Forum
Chevy Cobalt Forum
Chevy Camaro Forum
Toyota FJ Cruiser Forum
Ford Truck Forum
88-98 GM Truck Forum
73-87 Gm Truck Forum
Ford Expedition Forum
Chevy Equinox Forum
Chevy Cruze Forum
Jeep Liberty Forum
Jeep Forum
Dodge Ram SRT10 Forum
Chrysler 200 Forum
Scion xD Forum
Scion xB Forum
Dodge Challenger Forum
SRT Forum
Nissan Titan Forum
Buick Enclave Forum
Cadillac Forum
Cadillac XTS Forum