This morning, I installed a set of smoked LED license plate lights I ordered through eBay. Here’s the link if anyone is interested.
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/183442025807
It wasn’t a bad job, it took about 15-20 minutes. The metal retaining clips weren’t too difficult to get out but they fought me the entire time trying to get them back in. You just have to be patient and hold the lights tightly while reinstalling the clips.
These lights are set up like the OLED Recon taillights; the wire from the light plugs into the light socket where the OEM bulb goes and then the socket plugs right into the housing like the OEM does. I zip tied the modules up out of the way around the license plate light wiring harness.
This is the retainer clip. Look up under your rear bumper and you’ll see the gray metal edge of the clip that holds the light assembly in. I used a plastic pry tool to pull them out and they popped right out with a little prying.
(I tested each side before I reinstalled the clips) They work great and I really like the way they look.
Now I need to upgrade my reverse light bulbs so I can actually see behind me at night when backing up. Any suggestions?
Sent from my iPhone using Tapatalk