Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Yup, looks full. I’ll send a picHave you pulled the dip stick and checked the oil level?
I used Mobil 5w-20 full synthetic.Oil pressure is usually measured in PSI.
Could an incorrect oil type have been put in your engine? This could result in a drop in pressure depending on its characteristics. Just thinking out loud.
Ok I checked the cluster but couldn’t find it but I’ll look againEither your analog gauge on your cluster, or you can page through the menu on your EVIC until you come to the "Vehicle Info" page then use your right/left buttons on the steering wheel until you come to the "Oil Pressure" reading. Should read somewhere between upper 40's and lower 50's PSI.
I haven’t driven it since the problem occurred and I posted here. The problem came about 2 days after the oil change.If the oil level was full 99% this is the issue, it should have been common knowledge just change this the second you had an issue after an oil change. The orange can of death is a real thing, dont drive the truck til a new filter is hanging on it. Mis well go to oil stop and just get another oil change. If m1 uses louvers could be closed louvers in center tube as well.
I got some time today so I’m going to try that. What filter do you recommend I use?With oil pressure that hi, bet your oil filter isn't functioning at all, change that and see what happens.
Is 58 your oil pressure, or is it your remaining range in miles on what's left in your gas tank? I ask because above the number 58 is a heading that says "Range mi".View attachment 531872
Here is the oil pressure gauge in the top left. I haven’t driven the truck in a couple days and this was just after I started it today.
Royal purple 20-820 would be my choice available through Summit Racing other have been using Fram XG2 ultra synthetic, or the Mopar MO-41.I got some time today so I’m going to try that. What filter do you recommend I use?
Is 58 your oil pressure, or is it your remaining range in miles on what's left in your gas tank? I ask because above the number 58 is a heading that says "Range mi".
Then going by the analog gauge in the upper left, it looks fine to me.Changed to Fram filter before I read recommendation.
Still getting shaking and codes:
P0306
P3497
P1416
Off to the mechanics next few days I have time, I’ll have an update for you guys.
I truly appreciate all the help!
No 58 was the range, I was low on gas.
The top left gauge is the oil pressure.
I couldn’t figure out where to find that screen. I’ll try againThe oil pressure I saw was just the sweeping guage from low to high. It looks fine, but everyone is talking about scrolling through and putting it on the oil psi screen, which will show exact oil pressure with a number in psi.