04 Ram 2 gauge Pillar Pod with handle? Ways to mount 2 gauges?

[Joe.G]

Hi, i am looking for a pillar mount that can hold 2 gauges and still have the handle. So Far I have only seen SRT type with 1 gauge or the mounts that do away with the handle and have 2 or more gauges.

Does anyone make one where the handle stays?

Will the SRT single style fit my truck?

Dodge RAM 1500 2500 3500 SRT10 A Pillar Gauge Pod Mount New Mopar | eBay

What way are you guys mounting your gauges?

 

[CorDog009]

The SRT style will fit. I had ordered one for my truck and then it got backordered so I cancelled it and went with a single Autometer steering column pod instead. I'm not sure if you can get a dual gauge pod and still keep the handle, in my '03 dually i had to remove the handle to install the dual gauge pillar pod. They do make a dual gauge steering column pod like the one I have though.

 

[Joe.G]

Yeah i am not a fan of the Column mounted ones in out truck just because they block teh dash a bit, i may just go with a SRT mount.

 

[HemiLonestar]

Once you go to two gauges on the pillar the handle goes away. Another option is if you have the space in the center bezel (under the HVAC controls) you can put gauges there with this:
Auto Meter Triple Console Bezel Gauge Mount for 2003-2007 Dodge Ram 15021 - Parleys Diesel Performance

 

[Joe.G]

I do like that mount but I use that cubby alot for my phone and ipod and what not. Guess I ll go single gauge with SRT mount thanks.

 

[HemiLonestar]

I was thinking about using it for gauges since I'm doing a 4th gen console install.

 

[Trail3n]

I've been tossing around the same question. I have three glowshift gauges already and this pillar pod mount( 03-09 Dodge Ram Taupe Complete Replacement Triple Pillar Pod ) but am leaning to getting an edge insight or scangauge 2 mainly to same hookup time. plug and done

 

[Trail3n]

you could always try this mount 03-09 Dodge Ram Cummins Full Size Dual Pillar Pod - Light Gray and think about cutting it down to fit with existing handle still in place. Ive seen others use a sheet of aluminum or some other type of sheet metal and mount gauges to. Gauges

Also found these just messing around
Windshield Gauge Mounts - WINDSHIELD GAUGE POD - DUAL ('03-'09)
Steering Column Gauge Mounts - STEERING COLUMN GAUGE MOUNT - DUAL ('03-'09)

 

[SilverStreak88]

You could always get the SRT-10 A-pillar with a gauge and then use a flat mount and screw is (cleanly) to the right side of the 1st gauge.... or just get one of these...



http://www.carid.com/auto-meter/dual-overhead-console-black-gauge-pod-mpn-18016.html

 

[Joe.G]

I like above the mirror mount, I wanted to screw one onto the Pilliar along with SRT mount. I am ok for now I just have the one gauge.